Flannel Guy DIY is a channel that helps with home improvement and DIY home repair that the average homeowner can do. I have been a DIY guy for over 30 years and have tackled just about every project at least once. Let me know what you would like for me to do next!
Your yard looks like it's a park setting or horticultural center. Very well done. Like to see all the various lights and cost in a video also. Thanks for sharing.
thank you and as mentioned in the beginning, I will have follow up videos that shows types and costs. I may release that one tomorrow if I can film and edit by then
How is it looking today. My back yard looked worse than that. i did what u did last fall. i also dethatched. i used the same seed, and mine is super thick. Did you do a ph test? Mine was very low. i raised it with JG mag-cal. Now i fertizle every month.
Listen, you said it doesn’t matter where the wires go in ! so what’s the purpose of having the letters written white black green whatever the color is?
I’ve just replaced my roof and sagging ceilings and found out that no rafter vents were anywhere in the eves and they blew insulation into it and covered all the eve circulation openings. My fan I found up there doesn’t work at all and I’m so glad I found the thermostat style one you showed in your video. I’m gonna measure the old one and install a new one in its place. Bless you for your information! I’ve slowly started adding new rafters vents which is painstakingly hard to do because you’re squeezing yourself to the lowest point to staple them in but I’m determined like no other for this situation.
I would recommend ceramic window tint. It will keep ~60%+ heat from entering your house. ESPECIALLY on any west facing windows. Blinds won’t stop the heat.
Those said LED lights , I bought so much of those and come to find out I had to replace them so many times in less than a year. They do not last. they lied
Just het a cheap $10 4-1/2" grinder from Harbor Freight and a flap disc. You can sharpen your blades in a matter of minutes wkth a razor edge. Then balance the blades on a plastic blace balancer or on a nail. Files are cangerous if you slip and too time consuming.
I work for a spring manufacturer and the tape is actually a spring. Due to the curve it always wants to return to the coil. The same type of spring is used in modern windows in lieu of the old counter balance weights. Thanks for sharing!
Would’ve been easier to strip the wire before putting it in the inlet box. Also it would’ve been easier if you had everything mounted and fed it after. You were clear on both sides
I've replaced every bulb in my house multiple times with LEDs and have owned my house for less than 10 years. The 10 year claim for LEDs is bogus (in lab settings) nonsense.
All the outlets with aluminum wire I'm dealing with have a red and black wire to one side of the outlet and a white to the other side with no ground wire connected. How do I go about using the connectors?
I have two Hoover Onepwr 4.0 batteries, relatively new, that just died last weekend.. both at the same time. 2 separate charger now flashing the defective battery flashing red. I purchased a knock off replacement from Amazon that works fine but I'd like to try and revive one or both of the other two. The pins are not labelled but I tried to connect one of the batteries to the new one as indicated.. outside pin to outside pin on each but it didn't work to revive it.
When, and If you have to mix a large amount... you can always mix on top of a 8'×10' tarp. Don't be afraid to get down and dirty. (For you people with Alergies, don't forget to use a N95 mask.) Just saying....
Can you test that an outlet is downstream by, say, plugging in a tester into the outlet, then turning off the GFCI outlet (by pushing the TEST button)? If the tester goes out, then you know it is downstream --- otherwise it is not.
Before winter, OPEN & shake the water out of your hose sprayers. I shook the water out but failed to open the sprayer for years --- and always wondered why they were broke come spring time.
Great video. Only suggestion is using a level that can be attached to the rope line. They sell small ones with hooks that can be attached to any thin rope line or chalk line.
For whosoever shall call upon the name of the Lord shall be saved. (Romans 10:13) Ye adulterers and adulteresses, know ye not that the friendship of the world is enmity with God? whosoever therefore will be a friend of the world is the enemy of God. (James 4:4) The LORD is nigh unto them that are of a broken heart; and saveth such as be of a contrite spirit. (Psalms 34:18)
Just sayin, heat rises. Shoul'dve used the gable as a intake, then use box fans mounted on the rafters to push the hot air up and out the ridge/roof vents