My car lose the 12v tension from the top first wire after 1-2 minutes. I mean if is activated from that button,it will work but if you leave it for like1-2 mins,it loses… Tried with another unit and it does the same thing. Maybe both units are dead. Any suggestion pls ? Checked the battery from the remote,it stays like 2,96-3v. A deep looking at the cables ?
Both of my fobs are not working and all fuses seem fine. I’ve opened up the diversity antenna and looks pristine and dry no corrosion etc. I tested the voltage on the pins you did and only had one live with around 4v. Is this the supply side and is it likely that the wiring near the hinge has been ruptured?
Hello! thanks for your video... I have checked the readings with the voltmeter and are very similar to your "good" unit... shall I give it a go and replace the module still?... its driving me nuts not having the rm operational....
At the point when I shot my video I had already replaced the wiring. The broken wire or water ingress caused the failure of my diversity antenna. Replace the wiring first then see if your fixed, if not then next phase is check the voltages on the antenna
If you just pull back where the grommets seal to the body and then give a pull on each wire individually you’ll probably find the broken wires pull out