if a EZ-Sensor has been programmed for car "x", can it later be programmed for car "y"? As in, if I made a mistake and programmed for wrong car, can I correct that by programming again for the correct car? Tried to call Schrader tech support to ask this question, and they never call me back!
I found an easier way. I have a small dump trailer that is pulled behind my lawn tractor. Removed both wheels and took them to my auto mechanic and he replaced the valves for no charge. Of course I've paid for it many times over with work he's done on my car...but he's done other things as well for me with no charge...he's a good guy. And I don't have a fleet of vehicles to maintain.
Now I'm a little more prone to gravitate towards the TNT GOLDEN but we had this bar and there wasn't anything wrong with it except because of the narrow tips, we wore off the corner using it to lift the tire, I have always thought that this bar is better for straight in and out, compared to a rounder "spoon "that is better used with a circular motion, but anyway, I named it Gene Simmons. (from the band KISS 💋)
Check the air pressure in the tire-drive with the light on- put that money into your gas tank and stop and get coffee and donut. You’ll be money ahead.
A meticulous mechanic would use a valve stem that matched the other stems on the car. By replacing a metal stem with a rubber stem you now have an odd-ball wheel in the group. How can anyone believe this is acceptable? I bet you guys leave your peas and carrots mixed together on the dinner plate too. Disgusting.
Hey folks, I wish I could add a picture to the comments but it won't let me. I have a 2007 camry too, for the life of me I couldn't find it either. Get out a light and bend down, put your glove box all the way down. The button is to the left of the glove box, right next the pocket/storage insert (lack of a better phrase, sorry!) It isn't on the side of the glove box, or the side panel it's "up" and underneath. If you oven the glove box, get down there a little bit with a light you'll see it, I promise! Wish I could figure out a way to upload a video or pic, sorry guys. Have a super day (no idea if this is where it is for any other cars, but it is for my 2007 camry) 😊
I would think, have had pretty good service from All Tire Suppy in Houston Texas, but I think they are Asian oriented, and if you can't get them to ship there, you might try MYERS, AMISH oriented. Kentool is in Dayton Ohio, tire,aerospace oriented.
Do NOT buy the APS3000! After 1 year, it's a huge disappointment. Bead blaster does not work, center clamp requires daily maintenance and fails to hold difficult assemblies, and the motor slips while dismounting stiff tires. After spending $20k the sales rep wouldn't even return my call, instead had the service rep call me. Just bought a Hunter Elite aligner and had a much better experience.
What do you mean by "difficult assemblies "? Also, I have a coats EX7 series and the motor slips, but I know I need a stronger compressor. These machines require 175psi MINIMUM!
why are they called valve stems when they aren't?. They should be called valve extenders. Its very misleading and confusing. I only found this out because a commenter on Amazon said they aren't for replacing existing valves stems.