Problems with this video: 1) very difficult to understand spoken words, especially while the engine is running; 2) Shawn at several times covers the view with placement of his hands!
why don't you recommend it? looks clean. the only question - how to find the leak? just turn it on when it was low on freon and spray soapy water everywhere?
i've done this with a hub motor, i used a bigger wheel, it certainly works, cost more battery tho, and if you can make the mobility scooter blind to speed, then it will be faster too.
Leaving it as you got it is the wise course, you’d have to spend big bucks to get a proper fire blue job like the original finish. . Word of warning though, don’t shoot high velocity rounds in it, especially Stingers, it’ll damage the mainspring housing over time.. Stick to standard velocity only. They came out with an improved mainspring housing in the late 30s that could take HV but they rarely turn up as parts.
Was there evidence these people were dealing in drugs or is this all speculation? Personally I don’t have any faith in the Polk County Sheriff’s Office as I know first hand just how dishonest they are.
Omg my dog too she be acting stubborn and then I’ll act like I’ll take it away and put it in my mouth then give it back to her and she’s ready to eat it 😂😂😂
Hi thank you for making this video and I appreciate your tip about putting another. Filter on the back of the air conditioner I'm going to do that I purchased a new Cost way 14000 BTU , last summer I live in South Florida I don't care about how the painters tape looks.😂
I have the same lathe and got the eBay/ali express ELS kit and love it. $300 and worth every penny. Does degree indexing, variable speed manual turning, automatic turning, any thread pitch you could want. The install is a little involved, but not bad. Never have to change gears again. It’s so nice if you do threading and want to change turning speeds quickly
Dude you haven't shown us how you did anything We don't know if you really did anything or not we wanted step by step recharging methods of how you did it not afterwards 😮
instant thought, bend the fork out a few degrees, bend the upper fork out and bend the lower fork back have an inverted L. my bad, my ascii characters are limited to ½ and ¼
Do you have the part number of that sticker shown in the video? I think I have the same inverter but can’t find information on my particular model. Thanks!
Can you tell me why they use a cap? A wiring schematic would be nice, I would like to understand the theory, I have a background in electronics, I have never seen one until today.
starter motor relay switch any car with same ignition problems by pressing your finger on solinoid gives illusion of key hitting start possession good luck
Hi I watched all of your onan videos I'm working on the same thing minus mine isn't the emerald model... Question what kind of spark plugs did you use and what was the gap.. what is the model number of that K&N filter.. the funny thing is I work for K&N