No we haven't fixed it yet , we're just going to bite the bullet and buy a new fan motor and see what happens. Thankyou

A new combustion fan motor sorted it immediately. A very easy fit. Not cheap though, at about £250 😲

@@alistairross4317 ahh good. To be honest we haven't missed it just used the kettle for washing up and a little fan heater to take the chill off the van. But we know its gonna have to be done 🙄

We are just going to bite the bullet and buy a new fan motor and see what happens. Best of luck !

@@traceyperrin7926 Thanks for the replies, I've tested everything, I'll go for the motor also, My motor turns on and spins but then stops. the feedback from the motor normally opens the gas valve and then after you hear the ignitor. I'm getting none of this so problem is not related to gas or ignition, it is before. I presume my bearings might be bad and its drawing too much current. I'll also report back here whatever the outcome to help others. Pricey bit of kit!

@@rorycurley2651 hi, did you get anywhere with changing the motor ? I have the exact same problem. Seen RU-vid clip from the US where the truama dealer recommends changing the motor saying a possible bearing fault. Cheers

It was diode on the motor circuit board. Either buy a new motor or replace the diode