Thanks for the video. Did that but my watch is now stuck in rebooting mode. No idea what went wrong, the soldering seems pretty good, everything aligned and not touching.

Saved my watch! Requires some tooling and skills, but totally worth it. Thumbs up for you 👍

question? what temp do you solder? seems to me that cable tip would melt. Great Video!

HELLO

And use a magnifier lens to check that the power cable connector is well aligned with the contacts of the watch board. Otherwise it will not work. And be careful when bending and fixing the two buttons (back & power) on the case so they are not damaged when you put the board back to the case. Its very sensitive and small. And thanks for this video!

Best vid for this procedure I've seen on youtube!

Samsung service centre is telling me that I need to replace both display and button strip it cannot be done seperately

This video is really helpful, I'm in the middle of the soldering process right now. My only question here is then to make it get sticked into the motherboard we can put the soldering iron machine literally over the flex cable if i'm not mistaking. Is there any risk of touching the flex cable just over the area you want to solder as you did in the video with the soldering iron machine?

It need screwdriver Y 0.6mm size? Why you don't try repair the flat cable before changing?

Hola tengo el mismo problema, donde puede comprar ese mismo repuesto y como lo solicito?

Nice video! What's the name of the fluid you added before and after soldering?