Hey guys I ordered the alba a arm kit for my raptor and I got it in a few days ago me and my dad finally got the chance to go at it and the bottom a arms fit and the top don’t fit they must be off a different bike the stock sleeve I’m supposed to re use is to long and sticks out on each side I emailed you guys I’m hoping I’ll get to return them Thanks
Making some more progress on the Z950 HO. Data logging short term fuel trims, timing, requested vs actual lambda, pedal position vs actual throttle blade position, IAT, ECT, Manifold pressure, Engine RPM, speed, and calculated load are just some of the things I look at when building tunes. Not just Horsepower and Torque. There is a lot more to the science! HP and TQ are just a byproduct and bonus!! +15whp with just a slip on and tune. This is spark arrested and does not require servicing! Expect more from your tunes and performance packages. Dyno Chart in video!!! #albapower
You give such valuable information. I especially feel good where you drive the old axle out by using a 19mm socket to not damage the axle you're removing. I also like how you drive the new axle in with a hammer straight to the threaded tip using multiple uneven blows with your ball peen hammer. (no socket for protection) Your professionalism shines! Thanks for your teaching inexperienced ATV enthusiast the correct way to replace an axle!!
Ideally you want to increase compression to maximize power potential. You need much larger jets. I think some of the rubber pieces need to be switched for more ethanol resistant components. Float bowl, float needle, Fuel line, orings, gaskets. Also probably good to flush the system out with gasoline after you run it because ethanol absorbs water. Water rusts bearings and can cause hydrolock. For efi you’ll need to be able to tune ecu. More powerful injectors maybe, and more compression. Efi is nice because you can have multiple maps for various ethanol % even E100. Carb bikes it will be easier to have multiple carbs for different fuels
I have these on both my BFG's and my paddles. Super light weight and strong as can be. I polished mine, the aluminum is superb quality and polishes to a chrome like finish.
