This is Basha sailor by profession... Son of a small hard working merchant. In this channel i will try to give you basic information about Seaman life.. Life at sea.. Job nature of a seamen.. Basic information of marine engineering.. Basic maintenance on marine machineries.. Facilities on board ship.. Recreation onboard ship.. Challenges faced on ship... Safeties on board ship.. How to join ship.. Merchant navy... Information about day to day life at sea Disclaimer : The content and videos available in this channel are for reference and Knowledge purpose only. Please refer makers manual before carrying out any maintenance jobs.
Good day. One advice to you. Put new injector inside cyl cover,tighten nuts by hand and wait 20 minutes to warm injector by cyl cover.only after this your can do final tightening.
Sir, I have one doubt, bursting or melting of bursting disc depends on pressure or temperature? And bursting disc is fitted on intercooler or aftercooler then where is fusible plug is fitted?
Sir you Putting washer to increase height .......l........ I mean the dimension of washer is given in manual ......? Or we can put any washer ie 2mm or 3mm
we have to take from the lowest point for stern tube ....alwys there will be a specified point to take sample for stern tube but mostly people tke from pump purging line which usually dont give correct analysis report
FOBAS will be alwys available ...if not u have to take and refer previous oil consumption data for the vessel engine specified RPM from sea trial record and do the calculation for change over