I try to share factual info about varied interests starting from cars, healthy living, DIY projects, engineering and more, with a hope that it will make someone's life easier & better.
Buddy, the rechargeable batteries works with 1.2V, the alkaline ones work with 1.5V, this maybe the cause your keyboard starts to fault in the first 10 days
I saw your video for advance cleaning of rotimatic. I also tried to clean the same way but there is no option for advance cleaning in my machine so how to clean the water pipe inside the machine?
Thank you, this helped a lot! My input is to tighten the back a little, then the front a little, and just keep alternating between the two until fully tightened. Otherwise, neither will “catch” and you’ll keep turning fruitlessly!
I have the exact 2013 Highlander but mine does not have the pushbutton start...only a regular key in the ignition switch. I didn't know it was an option when i bought this vehicle new in 2013.
Great video! It’s surprising to see how outdated the electronics are, especially for a machine that's supposed to be top-tier. Do you still have your Rotimatic?
My rotimatic was purchased in 2018 and now it shows no text on the display. The display lights up without any text. I could also hear clicking and whirring sounds that it usually makes but without any text. Is there a way to fix it? Thank you so much for your help.
Hey guys, I have a 2011 camry with 149,000 miles and I don't think the previous owner replaced the transmission oil. Do you think it'll be ok if I atleast replace the fluid in the oil pan? Thanks for your answers 🙏
Go ahead, it's always good to replace the fluid. Remember it's just 2 quart out of the total of 6+ quart. Basically you will just drain and fill. No need to remove the pan, it would be added work without any appreciable benefit.
Have the same exact chairs with the same exact problem. Probably should have just gone with spraying sealant spray at joints first too. I went a bit more aggressive in mitigating with a combination of taking it apart at joint (removing screws from joint), completely drying out inside, putting expansion foam in at joints and drain holes, covering entire joint and drain holes with flexseal tape, and reassembly. Just finished today, so haven’t had a rain or two for result.
Sadlly, I did this step and I get to the setup and select my WiFi setup and enter the WiFi passcode and attempt the connection and I get the "circle of death" and eventually it timesout and I get the message the connection failed to complete and to try again. After numerous retries it continues to fail to connect. Thanks for the video help.