Тёмный
GasPedalGarage
GasPedalGarage
GasPedalGarage
Подписаться
Just bringing you guys along with us on the ride through car builds, shows, meets, mountain runs and the thrilling feeling of going fast.
New videos every Wednesday and Saturday! So come along on the ride with GasPedalGarage, and don't forget to LIKE, COMMENT & SUBSCRIBE!!

Follow us on Instagram:
gaspedalgarage
cbarber_mx5

Cammed 2.5L Turbo NC gets Dynoed
13:20
Год назад
Turbo NA Miata gets UPGRADES
12:45
Год назад
We Are Back, Why I left
6:02
Год назад
Cammed 2.5L Swap Install | NC Miata
8:50
2 года назад
Pouring the 42x40 Concrete Slab
7:26
2 года назад
Finishing the Cammed Turbo 2.5L Motor
18:11
2 года назад
Best Mods for C7 Corvette Z06
5:54
2 года назад
Building a 350z in 10 Minutes!
10:11
2 года назад
NB Miata Takes on Road Atlanta
17:21
2 года назад
DIY Big Aero Front Splitter | How To
7:30
2 года назад
Drifting the 230WHP Boosted NA Miata
13:44
2 года назад
Top 3 Mods for a Turbo Miata
6:41
2 года назад
Pulling the BLOWN Turbo NC Motor
9:37
2 года назад
Turbo NC Power Goals + New Wheels
11:42
2 года назад
Комментарии
@ulevlogs420
@ulevlogs420 4 дня назад
Just bought a Z HR this just help me out a lot
@barenekid9695
@barenekid9695 4 дня назад
Buy Cheap?? = Buy Twice and If DIM? Repeatedly
@philipgagne1852
@philipgagne1852 5 дней назад
Any tunning required for the stage 1 cams??
@iamart3mis956
@iamart3mis956 12 дней назад
I cannot find the other hood vents in this video any links for them?
@therealman5522
@therealman5522 13 дней назад
My key is getting locked in the ignition, is it the ignition switch?
@scottr3141
@scottr3141 22 дня назад
I keep my 01 at around 7psi, but at 10-11 it's pretty bad ass too. I'm trying to make my EBAy Chinacharger last as long as I can.
@danloosmore8099
@danloosmore8099 Месяц назад
If you do the calculation from Richard Holdener to workout the power level from a normally aspirated to turbo, then this car is 230hp at the flywheel @ 15psi. Subtract 23% to give a wheel figure.
@kayachan5198
@kayachan5198 Месяц назад
can you get fuel level to show on the pi dash?
@mr.adventure559
@mr.adventure559 Месяц назад
You didn't show us the interior.
@imxilty5371
@imxilty5371 Месяц назад
I did this raspberry pi dash and everything works until i crank the car itll boot up and idle for a couple seconds before dying off
@DragoMusivini
@DragoMusivini 2 месяца назад
I have Tein Flex Z Coilers/Hotchkiss Swaybars F&R/SPL Pro End Links F&R /Front SPL Outer Tie Rods/Kinetix FUCAs/Z1 Rear Traction Arms and Z1 Rear Camber Arms both race version.
@yOnKiNaToR
@yOnKiNaToR 2 месяца назад
Just saw this video, way late to the party. Who'd you have build this? I'm looking to do the same garage for my NC in Georgia.
@benbrown7941
@benbrown7941 2 месяца назад
Any mods under the hood?
@gustavogarza3644
@gustavogarza3644 2 месяца назад
Don't give a f*** about the Miata get back to the Pontiac
@litogames6153
@litogames6153 2 месяца назад
ustedes lo fabricaron o donde puedo conseguir uno?
@franklincountiesfinest9338
@franklincountiesfinest9338 2 месяца назад
That compression test made my bottom end wet 😂 All jokes aside,this gives me initiative to 2.5 supercharge swap my blown Miata engine
@joby1
@joby1 2 месяца назад
Must be june
@miataK24
@miataK24 2 месяца назад
Dumb question: The bumper cut is required right?
@carlosmelendez8317
@carlosmelendez8317 2 месяца назад
Do you have links for all mods?
@432b86ed
@432b86ed 3 месяца назад
But you can't sort the private sellers from the used car dealers. FB marketplace is a waste of time.
@johndevine6648
@johndevine6648 3 месяца назад
wait what turbo kit did you say again??? flying miata?? I think you said you have a flying miata turbo kit right?
@mr.adventure559
@mr.adventure559 3 месяца назад
Would a Garrett 3071 turbocharger be the best?
@GasPedalGarage
@GasPedalGarage 3 месяца назад
@@mr.adventure559 for more power yes
@AquaStevae
@AquaStevae 3 месяца назад
I love everything about this car except the hardtop. Putting a hardtop on a roadster is sacrilege. I'm a purist, and these cars are ragtop cars in their foundational heritage. Putting a hardtop on it is just wrong! It's like something a rich boardroom douchbag would do to a roadster. Can't ever accept that. But the rest of the car is excellent.
@Malficion
@Malficion 3 месяца назад
Before you buy Z1, look at GKtech and FDF, theirs look a lot beefier than Z1's
@dtruth5769
@dtruth5769 3 месяца назад
Does the bumber have to come off to swap light?
@GasPedalGarage
@GasPedalGarage 3 месяца назад
Yeah you would want to remove bumper as the bottom tabs on the headlight go under the bumper
@ahealthyperspective1283
@ahealthyperspective1283 3 месяца назад
Are they reliable? Have you had any issues with water getting in them?
@GasPedalGarage
@GasPedalGarage 3 месяца назад
Yeah they are reliable no issues with them at all
@ahealthyperspective1283
@ahealthyperspective1283 3 месяца назад
@@GasPedalGaragethanks.
@lejomdavid8538
@lejomdavid8538 4 месяца назад
Good introduction and info...but FBmarketplace is always flooded with Scamsters, which is easy to spot once you open their profile and see them have many listings of cars which is way too cheap. I was wondering whether there is a way to filter ads by avoiding these scam profiles which will definitely save a ton of time.
@KelvindeWolfe
@KelvindeWolfe 4 месяца назад
Short shift.
@gbass7328
@gbass7328 4 месяца назад
Who tuned your Z06?
@johnsmith-dm2tq
@johnsmith-dm2tq 5 месяцев назад
this is a bit odd but i have a knowledge gap and i cant find a video talking about the basics of building hp in newer vehicles. im old,50 almost and when i was 20 i loved working on cars and built a datsun 240z with a chevy 350 in it. i recently was given a 2009 escape with a 2.5l in it and have been working on it as my project car. i rebuilt my transmission and no issues there. now i want to create a little h.p. but don't understand how it all works with fuel injection and computers. back in the day it was just bigger valves, cam lobe sizes, and timing. idk anyone into cars and no one shows this stuff in a video cause it's not the sexy part. can you tune any computer? do you buy a new comp? if you can point me in the right direction that would be great. ty
@trevorblankenship2983
@trevorblankenship2983 5 месяцев назад
Wow. Wish I could could see what he was doing under there . Thought it was a how to video .
@gopherchucksgamingnstuff2263
@gopherchucksgamingnstuff2263 5 месяцев назад
Cool car man. I was just out of High school when it came out.
@1teamboy
@1teamboy 5 месяцев назад
At least now I know how to NOT shift my Sti
@thepilotmaster777
@thepilotmaster777 5 месяцев назад
Im building a 350hp miata and I want to know. What turbo is he using?
@aravindsekar9568
@aravindsekar9568 5 месяцев назад
Awesome 👌
@andrewvout9679
@andrewvout9679 5 месяцев назад
They are nice seats man, what are they out of???
@Cosman63
@Cosman63 5 месяцев назад
I know it's been 7 years and you probably won't reply but how long did the turbo last you and how did it feel?
@ktanagrl
@ktanagrl 6 месяцев назад
so this is where the meme originated.
@342design
@342design 6 месяцев назад
Money shift?
@assaulttheasphalt6638
@assaulttheasphalt6638 6 месяцев назад
For the life of me, I can't find this manifold for sale anywhere.
@payne709
@payne709 6 месяцев назад
Sounds like shit wound not recommend
@sosefit
@sosefit 6 месяцев назад
how long does it take?
@jamali76
@jamali76 6 месяцев назад
This is about the most useless video I've ever come across
@JunkerDC
@JunkerDC 6 месяцев назад
I had one of these years ago I remember it leaked oil all the time and the dash and seats cracked so bad i had to get covers it was a real let down I got it for $7000 in 2008 and drove it untill someone ran in to the back of it. Then sold it for $500. It sure did cost a lot and it ran on premium gass at that time it was $4.47 a galon it was a money pit for sure.
@thesamur1813
@thesamur1813 6 месяцев назад
I have a 93 na8c coming in the next couple months, love to see it, got a grade 4B
@Phalo_ap
@Phalo_ap 7 месяцев назад
What year is your car
@mathewsenn
@mathewsenn 7 месяцев назад
ex-wrx owner and current na owner, this pleases me
@grecoconduris6716
@grecoconduris6716 7 месяцев назад
It looked like a Piston pin
@charleslanphier8094
@charleslanphier8094 7 месяцев назад
Looks mod.
@zedxmike7214
@zedxmike7214 7 месяцев назад
I like the NC1 more than the NC2 and NC3 because the face is straight and not smiling