Why would you think that the fitting on the tool would increase the pressure. Where do you get your information?? Increasing the flow will LOWER the pressure. ..WHY did you mount the water trap High?? It should be at the lowest point??
Why do we get all Christian and Buddhist and say ghost when in reality, the odds of it being a physical thing vs fantasy are so much greater, be it earthly or outside from here; ie, space. String theory, etc.
Very cool thank you for the quick education on how to load the grand. My dad was 82nd airborne during D-Day in the Battle of the bulge and he was part of the Berlin occupation for us. But he only brought his 45 home with him he didn't bring the rifle. So I didn't get to learn on that so thank you for the quick education. And if your dad's still around thank him for his service
Everyone saying they are not for this or that. The package says zero. They are junk plain and simple. All mine have failed air hammer, impact gun or not. Thanks for the video as I was gonna try their steel ones. Forget it!
Very straightforward video. All videos on RU-vid should be this good and to the point. I am installing grille lights and needed to run the power control inside cab. The install video did a horrible job showing and explaining.
Thank you for this video. To the point in a simple way and with the perfect solution. Took me quite a while to decide to permanently mount a mobile radio antenna!
On small compressors like the ones you have, installing high flow lines, fittings and hoses will drain the small tank that much faster. Instead of the high flow equipment, increase the pressure at the regulator until you can get 90 PSI at the air tool. You may have to increase it to say 135 PSI rather than to 115 PSI with high flow equipment. High flow equipment increases the CFM which will reduce the work output of the small compressor. You need pressure not volume to run that air gun.
Thanks for this video . I was just looking for info on the Springfield action . I wanted to know what the on off switch was . Mine is a sporterized 300 win mag . I’d gotten it 15 years ago from a client that built it . He passed from als . I used it for hunting for many years . Had it not go off once and did t know the firing bin needed pulled out and taken care off . Thanks for the video !
This might just be the worst video I’ve ever seen. Zero accurate information presented, and even worse “examples of how to tell a real from a fake stamp”.
My friend was talked into buying a 11 cfm,gas compressor but it only has 2 tube tanks totaling 9 gallons of storage, it won't work well on his big spray gun. Myl little 30 gallon, 5 hp will get better results because of the tank capacity, for spraying cars, the pulse of the compressor piston has to be buffered. You can actually see lines in,especially flat paint from having a smaller tank
The thing about it also is it almost doesn't even matter if it has positive traction because BLD works so good... That said... Having both is phenomenal.
Thank you - I'm using my tractor with forklift attachment to pick mine up but want a quicker way to get mine up and this might be the ticket. I recommend everyone use jack stands and go a bit over the max rated capacity on all the elements of your lifting system from straps to the hoist. 1,000 pounds will kill you if it falls on you; most accidents happen at the home.
After this video was made I purchased a set of lifting chains made to lift engines. Then I mounted the rings of these chains on solid lift points behind the seat of the Scag. So these rings are on the machine and when I drive under the hoist I simply connect the lifting chains to the hooks on the Scag so I don't even bother with the slings. So it's a modification that makes lifting the machine even faster. I think a hoist is the best way to raise up a lawnmower for service. Even to move heavy things to or from my truck makes a hoist in a garage a must have.
