You do an excellent job of simplifying something I way over complicate Never worry about pleasing the negatives they will always be negative Great videos buddy all of them seriously!!
I watched to the end. Now I'm asking where do you purchase your material and a number of the material?. I know it's 100% poly, but I like how it's slick and shiny.
Hello Sr. I did watch your excellent video about placement on left chest, and my question is where I can get the ruler with collar mark that you showed in the video. I thank you in advance. Have a great day!
I bought a convector oven two year ago and never use it because the tumbler press seemed easier. NO, I’ve ruined at lease 15 tumblers. The good news is, I didn’t throw them away. So now I’m learning how to do epoxy. Anyway, I just ordered the sleeves and will be using the oven for tumblers and my press for cups only. Great video!❤
Hello! Thank you for this vid! :) May i ask if you have experienced the tracing not working? I have a 4 head tmfxII, and it uses usb linker, when i’m doing design tracing, it’s not happening. Any suggestions? I’m importing files using A - 4 using serial linker..
I noticed you don't do a heavy pressure and you don't wait to long to cold peal it, to me i never get bad ones because i don't specifically use exactly their countdown time and settings exactly... you need to figure that out on your own ... but their settings are usually decent to start trying then out... and i don't just pass a towel over the print i rub it not hard but firmly in all areas of the print especially thin lines i press and rub it.... then wait til it's fairly cool and peal then slowly unless i can feel it's releasing easy then pull it quick, theirs no need to waste money and pull it unsuccessfully just to do it quick.
Hi Juan loved the video very koool and a lot of information. I have a couple of my coworkers are going to retire by the end of the year. Would like to have some Jerseys done for them. Let me know if it's possible, thanks
Thank you very much for your video. Was the heat transfer time insufficient or was it cold torn? I am doing a small business of heat transfer printing, and then I want to try to use the family's iron hot transfer to the clothes, and finally succeeded, but very tired, very tired, I wish you luck
LOVED the video but, I'm confused...how could you leave the screen out in the light for so long while you put the vinyl lettering one without it getting overexposed?