You don't torque these. The procedure is 1/16th turn once crush washer touches then 1/2 - 2/3 turn to crush washer. These instructions are right on the box fyi.
I work for a few company and a oil and fuel guy. I’ll tell you right now hydraulic oil, standard hydraulic oil jack and other tractors things like that is typically a 10 W 30 detergent. Oil oil will have detergent in. It did not recommend using it for your compressor.
I like changing the plugs on my 2010 and 07 Saab 9-3! right on top! Easy peasy! I've got to help my son with his 2014 Crosstrek this morning. My other son has a 2011 Impreza and I helped him last week. A little easier than the 2014, but not a picnic! Yes, I had to use a magnet on the Impreza! One thing I might add- get a spray can of AeroKroil, break loose the plugs enough to free the crush gasket then spray Kroil into the plug cavity. Kroil creeps into spaces 1 millionth of an inch, let it set for a bit. overnight would be better, but 1/2 to an hour should do it. And, you won't find a better penetrant. I would never use PB Blaster! Nice video!
Why keep your black tank treatment with your dirty dump gear? You only use it inside, keep it inside where you don’t need gloves and sanitizer to use it
Upgrade to LiFePo4 battery, higher wattage/capacity inverter and solar panel...well worth the investment for boondocking. Great review, of course low cost RV's these days are a compromise while Airstream is ridiculously overpriced. Good luck.
great info and i agree change the oil sooner than later, its a long term investment if you change cars every 3 years dont worry about this but if you wanna keep your vehicle in good shape change the oil 30% sooner than the spec in the book.
Picked one up at a Swap Meet yesterday for $5. This is literally the first video I'm watching on it. I'll need to clean out the volume knob as you did, replace an antenna, and find a replacement knob for the tone.
I'm considering a 758 or 739. On another forum, X758 owners (4 of them) all complained that a carriage bolt on the auto connect lift mechanism rubs on the right side of the frame causing a vibration when mowing. Has that been an issue with your's? Also, do you find your 758 better at blowing snow than your 738 or about the same? Thx.
@JD-sq2vn I don't have auto connect, so I don't have any vibration when moving. When blowing snow with the x738 you could get the blower to bog down the machine and slow it down in deep snow. The x758 will lug down, but just keeps going. Feels like the x758 could shear a bolt on the blower before running out of power.
Great video. I like your calm manner and thorough explanation. And you are to the point with no BS'ng for the first 5 minutes. Thx for making this video.
I just paid $9.97 on this thing. If you take the black cap off the middle spring and load it it should work. It took me a couple minutes but i figured it out!
I just bought the green lamp at a thrift store for $2. One of the bottom contacts was corroded, but cleaned up easily and the bulb was burnt out. I replaced it with a Nite Ize high powered LED 74 lumens sold at Home Depot and it works great now! 💡
