@namratacraftpanel4224 Hi…use a medium viscosity resin for this effect. I use 2:1 from Esuoxsy. You have to drop the alcohol inks when the resin is not too thick nor too thin. In medium viscosity resin usually its around 20 to 30min timing. Depends on the temperature of the environment you are working in. Please test this on a small mold to het the timing right
Hello, can I have your contact number in person.. I tried as per your instructions.. but sadly not able to get neither Petri effect nor 3d flower effect.. just wanted to discuss with you where I am doing wrong
There is one question: I am staying in delhi and currently we are having 35-40° c temperature in day time. Also, i use 2:1 ratio resin... As per your expertise and experience, how long i need to leave resin after mixing hardener to mix alcohol inks etc??
@@CraftsWithKripa yesterday I tried after following all your tutorials.. but sadly not able to make it 🤐 Requesting you to lemme know you point of contact so I can get help and assistance 🙏🙏
@@CricPsyche ok...have not used it. I use 2:1 from Esuoxsy for this effect. When you choose a resin for a particular effect don't look whether it is 2:1 or 3:1 or 1:1. Instead look at whether it is medium viscosity resin. You can also contact the resin brand via Instagram and ask them if that particular resin can be used for a particular effect. For the above effect you need a little thicker resin which cures a bit fast. For the 2:1 Esuoxsy resin during summer time I wait maybe 15-20min after mixing to do the effect. The cup will start becoming warm by then
@@CraftsWithKripa after mixing I waited for 40 mins approx then started working.. 🤐 but no result came.. may be I am still missing something.... Can I have your point of contact so I can share you result.. that may help you to understand the problem
@CricPsyche Yes white sinker ink is denser than the coloured alcohol inks. When you drop the sinker white on top of the coloured ink it will push the coloured ink down to create the Petri effect
Hey... please use this method only on small items. Usually if the hole is small you can fill a little more hot glue over to cover it...if it's too many or too big it's better to do it again
You can use gloves to avoid fingerprint. Else use the flame lighter..not the flame torch..just the lighter...move it around the part where the finger print is...it should go away
@taranpreetdhadwal6206 Use a medium viscosity resin for the best petri effect. The resin consistency should be not too thick not too thin when you drop the inks
I purchased my pen silicone molds with refills and caps from Amazon. The refills 5.5 inches, but the tip is so much smaller than the straw. What do you suggest?