Welcome to SimpleTech. This is the place to show the simplest electrical circuits, creations and inventions, useful for life. We hope to receive your support!
Hello can i get some help please? i did all from video and everting is working only problem i have it only show me temprature. And when i want to change to other he give me temprature calibration and not clock. Any sugestions what i can do ? Thank you
Sorry for the late response. But maybe you've found the solution. Because the length of the video is short, I have not shown all the instructions for use. Thank you for watching!
yes without coin cell - but if the clock loose USB-Power you have to set the time again ... with coin cell time (crystal & chip) are still running but without display and correct time is coming back to display if USB is connected again without setting.
Not sure if this is still active but, I followed the tutorial as best as I could and my Display only strongly displays some sections and others are either extremely faint or not displaying at all. Any Suggestions? I assumed it was a weak solder on the display but when I resoldered it, I got the same result.
I would like to know about these VU Signal but to see the RF signal or how much is arriving at the receiver? And the sensitivity of, for example, whether it is uV or Mv or uAmp or Mv. I want to install it on an old radio. I appreciate any help.
This circuit design has a small problem, the 7 segments of each digit share one current limiting resister, the fewer segments are lit, like "1" or "-", the total current passing through the resister is smaller, thus higher voltage is applied on the led, it becomes brighter, and vise versa.
Awesome circuit! Did you just splice and strip a regular aux cable? Also what is the splitter you use to plug in the aux cord and the cord for the speaker?