How to make a fuck ton of power using F9:Put rod select to global, CR speed to 2x and enable continous CR transit, close the relief valves and turn on the pistons, drop the rods 25% (so for example if the rods were at 100% you'd get them to 75% and so on, repeat that until you get to 10% rod insrtion) when its at 10% you want to check the sync thing, if the spinny thing goes counter clockwise then dont turn on the valves (unless high pressure/high thermal power alarm pops up) if its going clockwise then release the relief valves until the spinny thingy is barely moving and its pointing up. After this you can sync the reactor, once its synced change the view to temp. and get the rods to 40% then you want to check the places with the highest temperature using the relief valves you can get the highest temp 820⁰ then you disable continous CR transit and set the rod speed to 1x then you want to quickly get the rods to 35%, when the highest temp reaches 850⁰ set the speed to 2x and get it to 40% again and release the valves to slow the temp rising, when the temp stops rising you shut off the valves and you just keep it stable. Congrats! Youre making a shit ton of power now!