Hello Viewers! Thank you so much for your support. I am an Electronic Engineer. I use to upload lots of repairing videos of different devices and Electronic gadgets. You will find lots of repairing stuffs on this channel. Best part is I definitely help to resolve my viewers gadget repairing problem. You can go through the comment sections of my different videos. If you face any problem repairing anything, you can mail me on electronicstkf@gmail.com Thank you guys !
Hello ! I have a big problem with the 24256e and pic on the rcf hdl20a, can you help me find their firmware or buy an IC with the software copied, I look forward to hearing from you, ,Have a nice day !
Hello ! I have a big problem with the 24256e and pic on the rcf hdl20a, can you help me find their Firmware or buy an IC with the software copied, I look forward to hearing from you, ,Have a nice day !
I have a broken DVA T8 amplifier. when the woofer is loaded, the signal is distorted. when the woofer is not connected I get a perfect sine wave. amplifier of the broken T8 (1), exchanged with a good T8 (2). T8 1 works correctly again, T8 2 gets the same problem. In other words, it really depends on the amplifier. anyone have any idea how this is possible? MF and HF work properly. i hope someone can help me
hi, my front speakers sounds big short noise then push protect error comes, sometimes it works fine , sometimes error comes on booting, my issue is random like this and on fm mode this short noise comes on empty bands but no error
Maybe a strange question, but I lost the volume knob. Exactly the one that is in this video. Do you have any idea where I can order a new one. It was lost during a rent out :( Thanks for the video. Best regards from Sweden.
Sir 5 volt 60 amp SMPS problem I connect the series power supply in SMPS series lamp is continuously on off condition what is problem and any salustion
Hello, have you had to repair the JBL Cinema SB160 soundbar? I replaced all the faulty components, the diode bridge, the transistor and the 1kOhm resistors. After the diode bridge failed, the voltage was very low, about 2.5 volts, the same on the network capacitor. Can you tell me what the problem might be?
Hey, I found an old Companion 5 system, but one of my satellites has a broken-off connector. Any idea what kind of 4-pin connector they use, will mini molex fit?
Sir Actually it is some especial type connector, u need to take broken sample to any electronic components Market located in your location, & i am sure u will get it.
