Bravo, you sir are one of the few who actually convey the proper way to descale these machines. So many tubers show improper quick fixes that circumvent the process, and in doing so will shorten the life of the machine dramatically. Anyone reading this, this is the Proper Method to do the descale process!!
I replaced the suspension rods, after a few loads it keeps saying "unbalanced" I found a RU-vid video comment from "@gened9632" and I want to share it with everyone: Perform a balance calibration when you're finished. Hold down "Temp" and "Delay End" buttons simultaneously for a few seconds and when it reads "cal", press start. It takes about 2 minutes to run through.
Already replaced the rods...nobody mentions the nut..went from constantly getting a UB code to a UR code..some loads would spin out. Others not at all. Previous repair..they replace only one rod instead of replacing all 4 for even wear. One of the rods was shot! So next is the nut. I already ran the diagnostic mode and it gave me no info but a ok!
This clip did not help us the light remains. Just my luck.time for a new one.I can't stand that frigging light.it makes me nervous too much.I have boundaries.
This is the procedure for descaling. If the light stays ON you want to try to add descaling solutions you may find online. If that doesn't work either it may be time to replace the bolier
Just did as you recommended and my grandson wouldn't and guess what ..Your way worked..Thank you so much..Clean machine and grandson who will learn to listen...
Blinking cooling means The thermostat is into a 5 min delay so all the oil and refrigerant cools down after use ..now if you have a soild COOL that means the thermostat is doing its job.its up to you or the hvac tech to figure exactly why your not recieving Cold air ,
In rare cases there can be a build up of gunk in the outside of the basket. It cause the holes to clog and will not spin the water out fast enough. It willl also make your machine get OB.
Having trouble finding a replacement torx screw for the map sensor at the intake manifold, it looks like bolt for the throttle body only smaller, online extensive searches come empty and have ordered countless wrong bolts from Fcpeuro, any help part# and size l think it's t20 but I stripped out the head that's why l need new one.