Thanks it worked first try. I pressed buttons and it looked like it was not doing nothing panel didn’t light up except S E but after few seconds it cleared it. 👍
Am having a issue where it’s not cooling, i unplugged it for 5 min, reconnected and try again but now it’s blinking 81-C and I can’t change anything, do you think that it might get damaged?
I want to thank you for your expertise and the video it did the job even though mine is a different model I just follow the same commands, again thank you. 👌🏾
This is a great video, but if he is a plumber or handyman doing work for customers, family or friends, he should do a better job in making the repairs aesthetically pleasing and out of the way when finished. Especially if using for content with the proper names words for the repairs being explained. I would have took the time to remove the pots and pans from underneath for adequate working space and cleaned and flushed the drain tube and dressed the drain tube up HIGH with a more pleasing loop. A high loop is actually the proper fix for water not going back into the dishwater.
You understand how the water goes back to the dishwasher but not how to stop it. You need to get a pipe holder to fasten the drain line to as close to the countertop as possible. That way, the water has to completely fill the sink for it to go back to the dishwasher. I can see doing this and adding a knot could make it so hardly any water sits in the dishwasher after it's drained but a knot by itself is not enough. With a knot, if someone likes to fill the sink or empty a bucket, you're going to get a lot of nasty stuff everywhere.
If his method doesn't work for you, I have a different way that may work for you ⬇️. I tried his method on my refrigerator, and it didn't work for me. All it did was make the screen go blank for a full minute, but when the sreen came back on, it still showed the "0F" code. Nothing changed. 🤯 UPDATED FIX BELOW⬇️: So, if his method didn't work for you, try holding down the "Freezer" and "Energy Saver" buttons at the same time for about 10 to 15 seconds. This worked for me. It's certainly different for different year models. So, if your fridge is an old 2013 model like mine, this should work. The model and year are usually located on the wall inside the refrigerator next to the door.
Before connecting the hose to the garbage disposal, push the hose as high as you can towards the water valves. Than, connect to the garbage disposal. Water wont be able to get to the top of the hose while washing in the sink. Unless you have a blockage in the P-trap or down stream. It makes it look more professional not having a hose all knotted up.
