Welcome to the Official Race Face MTB RU-vid Channel , where we showcase the latest videos to keep you stoked and informed in the mountain bike world; featuring our factory riders, new products, events, and installation videos.
So if you’re just getting into mountain biking or a seasoned vet looking for inspiration, be sure to subscribe to our channel for the best mountain bike content.
Born in 1993, and raised on the ultimate mountain bike proving grounds - the North Shore, Vancouver, BC - Race Face has been designing and manufacturing leading-edge performance cycling components, clothing, and protection.
I was able to loosen the nut by wrapping it in electrical tape enough to protect nut, then putting in a clamp vice and tightening little bits at a time to avoid bending it. I'd tighten, then twist seat post and insert tube. If the nut spun too, I'd tighten a bit more until finally the nut didn't move, only the posts. Took tape off after all assembled and no marks.
RaceFace did an awesome job designing this thing. well done. installed mine last night. And No, the tube straps aren't hard to install. some people are just betas.
Great video, but please describe here Chester installation. Should the grooves that are parallel to the bar sit where your fingertips are? Or do your fingertips rest on the old-school mushroom texture, and the parallel grooves under your palm? I ask because if the grooves are sitting where your fingertips wind up, the logo is sideways for me.
So sick!!! y'all crushed it. Can totally relate to finishing something and already thinking about what's next and how you can push more. Can be so hard to take a moment to appreciate what you've accomplished. You inspire me <3