Whas this somekind of parody how badly diy video can be shot😂

What torque does the motor leg have Thanks

reminds me of the listening comprehension exercises in school..

Straight forward, buddy 😊

Cheers Pal

Thxx same fould , part2?

Thanks mate that was very helpful, one thing I had to do on top of that was to unclip the two plastic pipes that run horizontally above the manifold and swivel the rightmost clip 90 degrees to get the manifold out over the rocker cover, I was thinking I may have to drop the engine mount off for that extra 1cm but thankfully not. Don't know if that's specific to my van year which is a 2004.

How to change oil in manual transmission?

Thanks a million !

Very helpful Liam, thank you.🙂

what size is the nut that holds the drum on?

Haw mm box you use

Carburator cleaner?!!

Dwell angle bewin 48-52 grade i think..😄

come on mate, focus

Would you know if you can vice grip the pulley on these alternators, in order to remove the splined nut holding the pulley on? Cheers

Squeaky shoes 😅

Gold dust mate 👍👍

Lot of comments here asking about removing the filter housing. I did it with a pipe wrench and it was very easy to do

Hello, the engine of my car is a 1.7 turbo diesel Isuzu engine, it starts late. after starting, when I turn it off, after waiting for 20 minutes, it starts late again but when I turn it off and don't wait too long, it starts quickly within 5-10 minutes

Hi what size drill bit

Very useful, in Spanish there's no video. THANKS

Hi can you please help me with identifying which type of alternator does my Chevrolet Matiz have? Thanks

do you have to take the brake line off or can you leave caliper connected to take piston out?

my car sometimes starts good and runsh smooth but sometimes starts poor and runs very glitchy. Can it be a problem with the valves or if the valves are faulty, the problem is consistent?

Thank you!!!

Thank you❤

You want to upgrade to candlelight mate that’ll brighten up the place

Thank you

What socket size do I need for the cylinder head screws?

Easy ??

Can't understand a word you're saying. Volume too low...

Finally, a video where the mechanic works through real situations in real time. Thanks.

Thank you so much for making this video. I couldnt have changed my fiat scudo plugs without it. Good man, thank you.

Would this stop the turbo working on the motorway as i can get turbo working in lower gears round town but as soon as i get on the motorway in higher gears theres no power or response.

Thanks for the video. Can you tell if it matters which side does bearing goes into the hub?

One should not hammer or press the inside of a bearing !!!!!!!

What language is this? Subtitles please.

What is this strange language this dude is speaking 🤔

What is the socket size for cylinder heads bolts?

What did you do after you cleaned it

Thank you sir ...

would ne nice to know the part numbers.

nice job but i think i should change everything water pump and bearings etc but your tip was great thanks for the attention given big hug from Portugal

I am.having the same problem! Gonna look at it tomoorow. 👍❤

How did u take it off

Will oil leak when I change it?

Is that normal to have as much oil gunk there?

How to kill a wheel bearing

Brilliantly direct solution to problem Nissan should have sorted out years ago. These sorts of ball joints get CARTHRITIS!