Don't worry.. if ur professional than 2 years are sufficient, it will do it's job,... if ur using it for home than it will last long.. mine is still working like new after 3 or more years. Did greasing on gears once
Dont know bro... If u r professional i wud suggest u to go for high ampere.. If ur diy i would suggest u to but mma+mig which will cost u 9 to 12k on amazaon
Cant get a quality set in low budget in India ,we need to spend minimum around ten thousand rupees , all other cheap products are looking fancy but useless ,which could be used to repair damaged threds on soft meterials
I neber tried 5mm.. I use it as a hobbist, me not professional... But machine quality is good.. I just uses 1 unit of electricity to melt 3.2mm 10 electrodes
Agar andar se disclour hua hai tou nayi hi law.. Aur agar sirf dhool hai tou visor khol ke headlight ka bulb nikal ke wahi se pressurized top se saaf karna
@@Dude_Shakir time consuming.. Use first 220 grit waterproof sand paper, then 400grt then 800. And at last 1500.. After task is completed then use waxpol polishing compound. I restored my tata nano cars headlight this way...
Pehle hammer se mar ke deakho pin par agar nai tou Dousri pin sath hoti hai dusri try kar ke deakho.... Agar phr b nai tou apka particular unit kharab hai.. Jaha se laya hai waha dusri le aaw.. MINE IS STILL WORKING VERY FINE
Use it carefully it is very powerfull machine.. Never use with single hand use two hands when operating.. Never attempt to drill like this( when u drill 9mm and then want to oversize this 9mm drill into 10 or 11mm ) it will catch into metal n will either break drill bit or twist ur hand, very very powerfull
For high pressure not recommended.. Otherwise u can grind anything using respective grinding wheel.. But one must do at right pressure.. If applied high pressure on wheel the motor may give uo