question. I think there is a mount already installed underneath my quad. approximately what is the measurement of the space between the ears that hold the A frame connected by the bolt and cotter pin?
jamie, great wood working, nice job. Constructive criticism, I'm certain that the Pioneer unit is out of phase, maybe I can help with your speaker wiring, and maybe i am wrong but its all i know in life. haha If you listen to a Beatles song your gonna get Paul or Ringo, but not both! Care to reply we can help each other...good woodworking skills man!
Just steps away from hauling several commercial mowers and all the essential equipment involved. There is even room for a box for debris. Your living my dream. Cunningham's Lawn Care
Thanks for clarifying that it's ok to use bed frames! I have a 6'x14' galvanized boat trailer I bought for $200 that had a wooden frame around it. It was rotted all around so I took it all off and I've been wondering if bed frames would work to frame it. I'm hauling a mower and SxS with it, so nothing over around 1200 lbs. Great video!
In many states you need a safety inspection to get a license plate. The state will require you to replace old tires, even if they have little wear on them, which of course is a good idea, so the owner may need to buy 4 tires.
Can some one explain the setting the valves part? I didn't quite understand what exactly was happening haha. I'm about to replace the head gasket for my t2200. wish me luck!
Hi Jamie, I am hoping you have some input for me, but first, thank you for the video. I have a LTX 1040. I have not noticed it going slow so much but I have a hard time climbing hills with it. When it stop while climbing i release my foot and push it down and and it wll go a little bit, sometimes i have to do this several times to make a hill. I replaced the belt and seemed to fix it for about 15-20 minutes. I will try and do what you have showed in this video but I thought i would see if you have any other ideas. Thank you and thanks again for the video.
Brilliant. I have an ancient Murray with stick in the middle between you legs. Getting harder to change gear. I have a "spare" tranny so would you say its worth trying to swap or something else I should do first? Thanks a lot for the video!
I have the same lawn mower. The mower should have a constant rounds per minute. However it changes the rpms from time to time (especially when the grass is a bit higher). The engine is than producing blacker smoke. I cleanded the air filter but it doesn't make a difference. Have you got any idea what the problem could be?
Black smoke usually means running to rich it sounds like a plugged up air filter have you tride to run it with no air filter as a test to see if the black smoke continues?
