I see this was a while ago. I ordered a rex from you a couple days ago and it has a clicker dial. I picked that one because of the slider dial instead of the clicker for fine tuning my low speed. Has rex changed to a clicker dial since this video?
Steve i didn't like that slotted rod being near my bobbin winder so I put a 3/4" piece of bamboo inside a wire connector, crimped and covered with heat shrink tube. Bolt the connector onto rod and fit into slot of positioner. Nothing sticking out to cut or catch stuff on. 😊
Hello, I removed the rotary hook that is connected to the shaft, but not being experienced (my mistake) I didn't leave it positioned in a "point" so that when I put it back in place it would remain in normal operation. now the needle hits the rotary hook. Is there any way I can put the machine at a "0" point and apply the rotating hook there to keep it working normally? I've seen the manual but I can't find the answer
نجح الامر بالطريقة الثانية في مكينتي singer 20u-112c شكرا جزيلا، عدت سنوات وانا اعاني من هذا المشكل ومللت من إحضار مصلح الى البيت والآن اصلحتها بنفسي. جزاك الله خيرا.
Thank you. I have a tony Eagle h305 im going to try tightening that check spring as im getting tiny dots of thread on the bottom stitches. I have tension nob as tight as it will go?
I inherited a Typical GC6-9 from my mom who passed away. Thank you for your videos, I am on the learning curve but am making progress. Looking forward to watching all your videos. Cheers from South Africa