Hey on the Leak detection pump that u working on, there’s 7 wires running to it. On mine either key on the black wire has 12.5 volts. But with key off I’m not getting 12 volts back there at all. Shouldn’t there b 12 volts running back there with key off? Don’t the pcm check it at night time?
SC430 owner here . Thanks for putting this up . I honestly don't know why Toyota didn't just go the whole hog and put the starter motor somewhere more accessible - like the middle of the Sahara Desert ....
Chú ơi cháu đang dính 2 chiếc spak 1 cái 2009 1 cái 2017 thay hết cảm biến rồi. cam cũg đặt lại rồi. Mà nguội nó ra khói trắg nhẹ nóng lên ko ra khói nữa. Hướng cho cháu kiểm tra vs ạ
Có lẽ xe bị lòn nhớt, cháu cũng biết đấy xe nào khi mới nổ ( máy nguội ) áp nhớt khá cao, áp giảm dần khi máy nóng, đạp ga lớn áp sẽ cao lại nhưng có thể không thấy khói vì gió 🌬️ ra quá lớn Cháu thử nhớt đặc hơn xe có khác không Lỗi bỏ máy cũng có thể áp suất buồn đốt thấp
Hi, I am Sakib. I saw that you are very serious about RU-vid, But cannot growing the channel. So, I analyzed your channel and saw that In your channel have many problem. If you can solve your videos will get more engagement. If you can give me permission I can tell these problems. . Are you allowed? Waiting for a approve to tell to you!.. Are you? Hope you are if you want to know. here or email? I am anywhere and How are you? I am good!@
If those fuses are causing the whole fuse box to almost come off you’ll be good bro lol. If you unbolted it coo.. idk why to test a fuse. Bolt it down problem solved lol. Are you’ll find yourself looking in to the “Control Area Network” Bro……. I seen a few good ppl lose there minds trying to figure the can-bus 😔
I am working on a 2018 navigator that keeps burning the led module for one headlamp then eventually the other side goes away too. How could I trouble shoot this ? The scanner shows short to ground on lighting system. It was in an accident and I repaired it.
@AutomotiveServiceExcellence just recharged it yesterday at idle with the ac on max and full blast... cold while it sat there warm when I started driving, it's odd, when it is cold outside I can't get heat, but when it's hot like today, all I get is heat, hot heat out of the vents
That Suction Hose is not any good now. As for the expansion valve, likely but not 100%. ANY obstruction will cause the same issue. Obviously does not have a Low Pressure Switch.
I checked my purge valve. No leaks and I replaced it anyway. It opens and closes with obd ii command. I erased code and it came back. Slight lack of power, but no vacuum leak code. What should I test next? Smoke test back to canister? @auto repair