Attention au volant moteur... La goupille de la butée doit être positionnée sur 3 heures...serrage pas avec clé à choc , avec dynamométrique😂😂😂 bon courage
Haha next time tell him to remove the piston and to put the shaft first in place and because it will be easier for him to match it with the fork of the sliding sleeve and this way he also won’t forget about the gasket
Don’t get tired my friend heat the inside a bit with flame ore put the whole bearing on a stove just to heat it up a bit and it will go inside very easily you will just need to hit it with a hammer slightly when it goes inside the sleeve
IF GEARBOX NOT CRUNCHING GEARS PROBABLY THE 3 GEARBOX SELECTORS NEED TO BE NEW. IHAD SIMILAR PROBLEM AND AFTER I CHANGED LEFT, RIGHT AND REAR WABCO SELECTORS MY PROBLEM MOSTLY FIXED. GOOD LUCK
