Hello. Can you tell me where is CG located?!

Brilliant video, I can knife edge my warbirds just about. One problem I have 3 planes 2 x bf109 no problems at all but my p51 worked great for one flight then the next I had no throttle.. switched it back to its own transmitter and it worked back to boxer and no throttle again?

Hi there, We flew two of these today for maiden, but we had to stop. Both planes had extreme vibrations on 4s, starting at half throttle and up. Props are perfectly balanced. Your Trainstar sounds also like it is extremely vibrating at higher revs. I think we need to make the nose/motormounts much stronger. Did you do anything about the vibrations?

Hey blowey, where have you been lately? Hope all is well.

Nice flying mate, im getting this jet after seeing this review, good to see you have a park in Australia you're actually allowed to fly, where i am in nsw there's signs at every park saying no rc airplanes and cars so im restricted to the beach and one high school on weekends 😂

44217 Klocko Spur

Can i fly it with xk a430's stock digital transmitter which looks similar to A220's transmitter ?

Nice colour !

Three years later and still absolutely relevant and useful.

Hello, This wing connector is a brass tube, it should be 32cm. It is shorter. 13cm for the left wing and 13cm for the right, the fuselage is 6cm. I tried to buy it but the diameter of this tube is non-standard, it is 7.9 mm. Standard tubes for RC models are 3,5,6,7,8,9,10 mm in diameter. Best regards.

I set mine up ok, but I don't see where you can adjust the gain.

THANK Sssssssssssssssssssss! Thank you! Greetings. THANK YOU for THIS very helpful recording! Dziękuję! Pozdrawiam.

Buenas, gracias por el video de la construcción, me parece muy útil. Una pregunta, qué configuración usaste? (Motor, variador y hélice)

Hi. I followed the steps and it didn't work for me. All the gyro setups worked. Have you actually tried this in flight?

Is it possible to set up the stunt button and lost model alarm too?

I don't have this issue but the wires to my motor are faulty and it turns off randomly. No help from support because of their 30d "warranty" (I'm used to 2 years in Europe). Looking for some help before I break something 😬

My T400 reads a voltage lower than the actual voltage. Consequently, one of my LiPo batteries caught fire while charging due to being overcharged. My advice to those still using this charger is to check the voltage per cell (especially 6S LiPo) by pressing the ⚖️ monitor button just before proceeding with charging.

s it also possible with xk a300 via sbus?

Should i get fhis as a first

U r pronounseing decals wrong its Dee-kalz

It's a bit tail-heavy. It likes to fly a tad nose-heavy. Once the CG is perfect it flies like it's on rails.

Hi there mate, enjoyed the vid and might give the hookle a go. I will follow your top on the landing gear and see how I go landing. Phil

Perfect landing 😂😂😂😂

Exerlent vid I have this very model and want to add flaps this is awsome Sir

Hi couple years ago you used a micro fs receiver on couple of planes just wandering what signal range were you getting putting one in the tempest if range is ok thanks

Nice plane mate❤

Hello. Can you please tell me what kind of varnish the plane was coated with? because I know that most varnishes can destroy the Styrofoam. Thanks in advance for your answer. Have a good day!

Thanks but... I tried to check where is Ground etc. on the plane plug and now it is compeltly not turning on.. Such a shame, it was verry nice plane...

Very clear and helpful, thank you,

I bought my first plane two weeks ago, after preparing with around 10 hours of simulator time. Unfortunately, the experience has been a nightmare from the start. The plane had issues right out of the box. It could turn right much better than left, and the beginner mode made it impossible to achieve reasonable turning rates. In mid mode, it was somewhat manageable, and I managed to get seven successful flights. However, today, when I switched to expert mode, the plane started spinning uncontrollably to the right and crashed (without any input). After replacing the broken propeller, I attempted another flight, but the plane couldn't fly straight. It constantly banked to the right and couldn't be trimmed. Eventually, it flew into the sun, and I lost sight of it. I spent 2.5 hours searching and walked about 10 kilometers in circles but couldn't find it. I suspect the faulty ESC didn't cut the power when it lost signal, causing the plane to keep flying straight for a while, making it impossible to locate.

Are these the RTF version or BNF? CAN I BIND MY RTF ONES TO THIS TRANSMITTER?

Awesome build video... are you still making videos..? Really enjoy your channel...

do a filp

same for Radiomaster boxer 4-1 M8? cheers :D

Any way to reverse sticks on default transmitter mechanically mate ? Only cuz I fly mode 1

The reason why it fell apart midair is probably because your speed was high and you pitched up fast, which increased the load factor on the wings

Excellent review Can you please help me with the exact Length of the Fuselage alone without assembly

I think there's some useful info in here. But, I just cant stand listening to a male talking like a Reject from English class. WHY do you raise the octave of your voice on the last word of most sentences?? Drives me insane!

Very helpful video Cheers Need a little help Can you please tell me the Plastic Fuselage alone exact length

Mine also runs on 4 cell Lipo. It is amazing plane. Extra weight not a problem

Hi can it be set with a v.tail? thanks.

Would this be good for my first plane? I already know how to fly.

Maybe its the servo end adjustment that ain not set to 100%, wenn you lower it it might not calibrate? Ist an option to try?

I have a Mustang, Messerschmitt, P47 Thunderbolt, Spitfire. With a lot of skill can land on the cricket strip on its wheels. Ok im jealous of those landings

Can the gains be adjusted on this gyro? My plane gets rapid vertical oscillation when I do a fast loop and switch into beginner / auto-level mode right after.

Very nice. Seems to want to stall easily on bank turns. Nothing that more power can't correct.

I have 2 new 60c 3s 4500 packs that are 325 grams..i am ordering kit version i have a nice 3536 1100kv which may also weigh a bit more than stock motor..anyway to me it looks like i may be able to get balanced without adding weight...thanks for sharing😊

all right fair dinkum

Screw those gyros...i never used them...when i did i alao had stupid crashes like you had...you have to have them set up perfect or you are much better off without them

That was a nice easy landing. This plane seems really locked in..