Why they market a device that cannot be used (under development) A car factory would sell a car without an engine, and then later send it to the customer. Lots of promises since May and no change. Chip copying is impossible!! Huge scam.
@@siegfredreginaldo yes by launch official site in page downloads software also in your tablet you have apk file with name base.apk transfer it on android tablet which you want to be installed
Same totally useless junk, not even plug to solder direct. Din plug to micro connector, but no micro connector to bare wires to make solder connection. Key reader / transponder reader function only. My xtool scan tool does more then this unit.
@@HardwareTX really I don't have a words, and I don't know what to said...and no have news from CGDI for that strange tool ..all people are very disappointed.....autel km100 is very better tool and no so more expensive....by that crap
I got mine today and have tried a few things and it feels like a totally useless toy, reads frequency and chip but can't do anything totally disappointing
TODAY IS THE FIRST TIME IUSED IT , IT ONLY READS REMOTES IT DOES NOT PROGRAM ANYTHING. IT IS UNCAPABLE TO PROGRAM A BASIC NISSAN REMOTE MUCH LESS ANY VEHICLE THAT REQUIRES IMMO INTERFACE DO NOT WASTE YOUR MONEY UNTIL ALL ISSUES ARE RESOLVED
@@carsdiagnosticlab do not get wrong Cgdi makes other products that I use and I am satisfied with them , I believe this product was rushed Not a lot of thought went into how the end user a tech that needs to program vehicle remotes and smart keys
I need help I have immo plus I want to learn about using the xprog3 and procedure for programming some vehicles If can get videos or maybe on pendrive or something i will pay Iam in Ghana Waiting for your response
You have two ways 1. To read old ISM an write to new ISM 2. With diagnostic tool Xentry/Launch/Autel to programming to the car just follow the instructions on your diagnostic tool.
@@carsdiagnosticlab to read from old one and write in new one is ok... But renew it and program with launch or autel that is the problem. It never works.
Thank you.Why didn’t you immediately write the full data of the original transmission into the new one via the imoprog function launch? Or do you not have the original file?
@@jetsetjoey its 100 necessarily for every programming on BMW to have voltage over 13v , why you can ask BMW factory.....with low voltage you can bricks the programming and you will have big problems
