@@SRadford just a cheap eBay pipe bender and as long as you use the correct size die, so it is tight on the pipe your bending and use patience I was able to get some nice bends
Nice work mate It looked like you were running pure argon on your mig? If so run a mig shield mix, which is 75% argon and 25% co2, it will weld a lot nicer. Pure argon is for tig welding or mig welding ali. I may be wrong and your already doing this, but just something i noticed. Helpful tip from a fabricator 🤙
@@nicholaswaddell4141 yeah ok never seen it before, just went through and found the one your talking about, not the same at all though there’s is like a little window that opens up haha 🤟
@@GoodVibes-ye3iy yeah righto must be different to how I remember. From what I remember the whole extra cab gull wing opens up. Been a while None the less still a cool build man.
@@nicholaswaddell4141 only one I found on there page was the top half folded up and looked like it was only like 100mm wide. Probably is other ones out there though. Cheers man appreciate it 🤟
Killer build bro! Haven’t seen a vid like this for a while cheers bro. Also how did you go on the engineering side of things? Thinking of doing a similar chop to my gq
@@darcylegrange1956 thanks man! Still going through the process at the moment haha. Just took heaps of vids and photos of all my welding and framework so hopefully gets through all good 🤟
Always wanted to do this. As it makes more sense to me than dual cab and canopy as stuff inside and can be reached. Also easier to do a pull out drawer kitchen setup as it's lower
If it cuts off its just like turning off a gas bike and having it in neutral, you would just be rolling. It would not send you forward. He was braking hard on the rear brake while going over ruts that made him crash.
