Thanks, Mr. Noodle! Very informative. I did bend the Schluter trim, but didn't cut back in far enough, so got a rounded corner. Easy enough to trim the corner of the tile to fit and I like the curved edge!
Nice video, good advice, but please don’t swing a hammer like that. Again, good and thorough advice, but choke up on that hammer…. just don’t swing it like that. Practice and you’ll get better. I’m not trying to be mean and I liked your video, but them hammer skills have to improve. You can do it!
Planning a kitchen backsplash project this weekend - I helped a friend set tile exactly once, so seeing you go through all the steps was really helpful!
Need to make sure tile isn’t set over those outlets, need to loosen them so the tile sits behind the flanges on the outlet. That way you can change them in the future and your covers sit properly.
V good instructional video….. But there must be a better way to design this, so the future repairs are not so painful….. I’ve to help a friend tomorrow to tackle the issue…….
This is an excellent demonstration of how to remove, repair and reinstall a pocket door. However, if you go to all this trouble, I would invest the $10 in a new set of tractors (rollers).
The main reason to use "painters caulk" (or Window and trim sealant) is because it can be painted. If you attempt to use a silicone sealant intended for kitchens and baths, they repel water and will also repel your paint.
HI- Is there any way to remove a factory preglued counter top . the top is cracked and I am trying just to replace it and not the base- irs from Wayfair
Also the reason for the repair is the back roller is off. The hardware is designed for front roller to go on outside track and back roller goes on the opposite side of the track.
My boyfriend has made a tool to reach back and unscrew the set screw. He welded a long piece onto the wrench. We will see if it works. I think the hardware was put on wrong in the beginning. I think both front and back rollers should be on the same track. Because you can't get the %$$%% back on track! I'll let you know if it works.
I have a pocket door that is stuck. There is an adjustment screw on the back roller. It is keeping me from removing the door. I am trying not to cut the sheet rock. Any suggestions? I call pull it out until that back adjustment scew hits the wall stud. I don't know what else to do. Any help would be greatly appreciated
Thank you. I didn’t notice if there was an adjustment on that hardware of the pocket door. It looks like there is a ratchet step bar on the hardware. Can you relate if that can be adjusted up or down if the wheels are still on the truck for a better riding door.
Great video! I have L shaped. Is it feasible to raise granite at one end, so that cabinet section can be replaced without removing entire counter to avoid damage. L is 6' x 2.5 & 10' x 2.5 = heavy
Thank you In years past I actually cut the drywall to access the rollers. This time I got the door out and back in three hours! However, you might add on item to your video. Sometimes when a door is sagging, like mine was, the track simply needs tightening. I could have done that without removing any trim.
