I propagate hydrangeas the exact same way. I would advise using large rubber bands or, what I generally use are 24” Zip ties to secure the bags near the top of the pot. If you need to mist the cuttings, simply slide the zip tie down, lift the bag to mist and return the zip to its secure position near the top of the container. Easy peasy!
It took 90 minutes (had to get on the computer to confirm where all the electric plugs went), but it worked. My AC seem very weak, even after changing the compressor. Now with new filter the airflow from vents doubled (the old filters were 70% plugged up) and the AC seems to be cooling just fine. One advice - when plugging the electrical connector, plug them in FIRST, then hand up the fuse tray, THEN plug the bottom ones. Also, once you find out the locations of the 4 screws on the airbox cover, putting them back is not too hard. Thanks for the video!!!!
Get yourself a torque wrench, dude. All those components need to be torqued to spec, not just "good and tight". You're probably overtorqueing everything, plus your torques will be inconsistent
Thank you a lot for the video ^^ I've read than the drain bolt under the engine is often seized indeed, so I plan to do just like you and only drain the radiator. I did not knew it was so easy to remove the overfill tank :D
Couldnt get it out on the 2013 model which is even worse. You absolutley have to replace the bearing and hub. You have to pull the whole knuckle unit and take it to the shop with the new bearing and snap ring. In most caes they can save the hub. You will need 4 new studs. The shop will tap those in for you as they put the new bearing and hub back together.
Nice. Just snapped a stud. Unsure if I cross threaded the lug nut, or if some other weird problem. Hopefully I can buy everything at my local auto parts stores. Would love to have it fixed over the long weekend.
Ordered the installer tool, and a fresh grinding wheel for my angle grinder. Will pick up one or two studs at my local AZ. (Likely two, so I can have a spare should something go wrong) Plan to do this on the 30th or 31st. Will update if I remember to come back to this xD I'm hoping there isn't much stud grinding needed. I'm comfortable with grinding a bit off so I don't mar up the threads. Hopefully not much.
Just remembered; Back when I got the car, at some point I didn't fully torque the lug nuts on the driver's front wheel. Didn't realize till there was this clunking sound for a few days. Eventually found that the wheel was loose. So all four lug studs on that wheel likely are damaged, and may snap at some point. Just picked up four new studs today. Tomorrow, hopefully all goes well ^-^
Worked! Was a little hard trying to pull the new stud through. The puller housing had to be ground, so the stud could be centered with the housing being flush on the hub. But it worked!
Thank you dude. I just replaced all 4 of my strut and coils, front tie rod ends, and aligned it. I noticed I had a light vibration coming from the front right tire. I double checked the struts and everything was perfect, that's when I noticed the blown motor mount. Thank you for this installation video!
hello! i’m currently having problems with my low beam lights, they won’t come on when i switch them on and the bulbs are new, but my high beams work and my fuses and relays are good. any idea what the problem might be?
Had to do this job on mx5 replaced dust shields at the same time . Bit more expense as very rusty shields almost fell off .common fault apparently. Good vid on doing the job .slide hammer only way of doing the job in my opinion. Thanks for showing great stuff .