I did exactly what you did and mine isn’t working. I set it up to auto-record but I can’t stop recording! Switch is working properly in BF! Good Video!
i just want to arm my quad (kylin) and just can't have my throttle to zero !! Even with end point at -140% on my AT9 it goes to 30 something on open pilot ... Sooooo frustrating !
is it better ? do i have to flash everything and make i don't know how many steps to achieve it ? It really feels like the beginning of computers, when every little things was soooo overcomplicated !
Good vid, thx for that. I have a Wizard X220S Quad, Omnibus F4 V2 Flight Controller, I want to flash mine from 3.2 BF to the new 3.5 BF, one problem, I can not for the life of me work out which one to select on the BF page, github.com/betaflight/betaflight/releases I am guessing it is this one: "betaflight_3.5.0_OMNIBUSF4SD-RC2.hex" Any idea if that is the right one? Have never flashed a FC before, I obviously don't want to mess it up, is that how you start off, download the file on that link or do you select the board through BF? Thanks again... you seem to know what you are doing!
Hi Good tute, question are you able to remotely take still photos? I can start and stop recording OK I can change modes and the green led comes on but when I operate the camera power switch on my taranis the green led goes off the blue one comes on and it starts recording Video. It works fine when I press the button on the split
Hi all. Can someone help. I got a new board and I have noticed on videos that it has a blue light and a green light. For some reason I only get a green light. What is the blue light and why won't it come on. Am a noob and not sure. Thanks in advance for any advice.
I bought the fs-t6 from here, and it works great! www.amazon.com/RCmall-Control-Transmitter-Receiver-Helicopter/dp/B01BZQ15L0/ref=sr_1_9?ie=UTF8&qid=1504684222&sr=8-9&keywords=fs-t6
7 лет назад
drop that damn noise supressor or squelch. use a dinamic compressor instead. If you have too much white noise on the mic, better post-process to denoise instead of using a squelch... otherwise, thanks for sharing.
I see, just got mines in today, by any chance do you know if i can access the osd using those 2 buttons on the side, have looked around online including the manual and cant get into it, dont have the wifi module and i made my own microusb to microusb but i cant get the runcam app to connect, it always tells me to use wifi. Any answers would be very much appreciated.
nevermind, found it in rcgroups, had to hold the wifi button for 2 seconds and then hold it for 2 seconds and hold it for 2 seconds and it finally got into the osd, so dumb