That's gotta be one of the calmest snakes I've ever seen! Spent half of the video worrying that he was already dead before he twitched a little. All things considered he could've gotten off a lot worse in being struck, good job paying attention!
My linkage both were broke they are not attached to the upper bolts your showing and I can't see them either side to see where to attach them. It's attached to both arms right and left . Also liked and subscribed this is my model also. Only mine is around 2005 I think I haven't looked it up yet. Thanks a million , and I love your music that's my jams!
This is a very unsafe trailer that Tractor Supply sells this problem should not happen. I'm on you video because I now have the same problem and now trying to figure out how to repair it. TC fails to assist with the safety issue or take any responsibility.
Buenas tardes Podrías ayudarme con esta duda que tengo Mira cambie el soporte trasero de motor honda accord 91 pero se rompió la carcasa o cajita donde esta la valvula solenoide la puedo cancelar o es necesario cambiar gracias
they should both be up and im sure the the problem is the hangers that hold the springs were not welded in the right location. the front hanger should be welded back a little bit more.
Here is the problem with that trailer your equalizer that's in the middle is not tight none of those bolts on the shackle straps or The equalizer is tight all you have to do is actually Jack that trailer up to take the weight off the tires and the axle and then you can maneuver that axles where you want it but all it is is needs to be tightened up that's the only problem with that trailer
To fix this spray everthing with w d 40 and let it sit for an hour. Put a little load on the front of the trailer. Then get a jack and push the lowest point of the triangular shaped piece up. It will pop back into place. I have seen this many times.
I'm sure this comment is way too late, but loosen the Shackle bolts on each side of the equalizer 1/4 turn, they may be too tight to flex properly to get back to correct after flexing. Use a jack to even the equalizers instead of a pry-bar. And last of all, if the front tires are down move the weight in the trailer towards the front of the trailer to stop the sway until you can get home to fix it. Check the measurements from the center equalizer bolt to the front and back hanger bolts to make sure the trailer is built properly.
I know this video is 9 months ago but I hope you return it. This Carry-On trailer company needs to have a massive recall on their trailers. Or have a video on their website explaining this situation 🤔 This is really bad. I hope it it resolved. Just let us know. Thanks for the video
This happened to me today. Had bobcat on site. Lifted it up from the back, put two wall blocks under the back tires and pry bar on the hanger. Was not easy but it went back to a “W” shape like it was supposed to be. Hope that helps.
I have a buddy his is leaking above the oil filter somewhere there is a line there would you know what this line is? I suspect its leaking from the line