Hi,do you need to change settings in the transmitter programm to use a LiPo batterie (in my SPEKTRUM i had to change settings from NiMh to LiPo)-also,if you remove the LiPo from the transmitter for charging,what happens to your programmed settings on your transmitter...i hope you don't have to re-programm each time after charging ?Last question-do you really need to discharge after each use ?
I was wondering if to buy a Lipo for this transmitter but when i come to think about having it discharged every time after flight i think im just gonna stick with rechargeable 1.5v regular batteries. I dont see any real advantages having the lipo.
Very usefull video!planning tou update!A quick question..after flashing-updating do you losing the preset models from the transmitter?if yes..is there any way to back up them.ian using full 15models..will be a big pain to reset them all up.thank you!
Thank you for the video. At 0:58, I noticed you say connect battery to channel 3 when ready for binding. Why just channel 3 and not any other channels from 1 to 11?
I bought this transmitter with receiver and I want to use it in my boat ... But when I plug the battery the motor after beeping start and dont stop . It stop only when I push into reverse .Any idea for set-up ?
Hello, one question I bought that device, but it does not detect the camera signal of my KY601G drone, will it have to see something that the camera is 5g?
I got one of these a few years ago, it has worked as expected, however a few days ago, I tried updating it. I used the firmware from the company website, and on their website it said that the V2 board, the version I have, is update-able on windows 10, however when I tried, it black screened, when I tried again on a windows 7, it still didn't work, and now I am stuck with a broken radio. I would recommend that you don't buy this radio, and if you already have it, don't update.
Sir ,I had downloaded the firmware from here which had .rar extension and when I had used windows 10 and 7 the AT 10II is not working showing black screen,please help.
Hi. I can't connect this SE100 to my CC3D. Radiolink told me I need to solder cables... It is possible to connect this GPS without soldering? I think the flight controller on your video uses the same JST connectors like the CC3d... Thanks!
I’ve been having signal loss issues well within the claimed 400 meters. Like at 100 feet. It lost signal today, fail safe kicked in, and prevented me from turning the car. Took out a front A arm and turn buckle. Little bit pissed.
Make sure you carefully open the receiver and clean it out.. I had one of these recievers unprotected on one of my bashers and it got a bunch of dirt in it and started glitching like crazy.. Clean it up and throw it on a balloon and that should help from giving you problems
Hello. I have a little bit sideways question: Is it receiving the "normal" 5.8GHz wifi network? Let me reformulate it, English is not my native language: may I use this FPV receiver for my android tablet (which has only the 2.4GHz) to connect to 5.8Ghz wifi? Thank you in advance :)
I can't get the R12DS working in Sbus via Naza m V2, I have 1 plug connected because the naza is already supplying power from the Sbus, at least that's what I assume because I do have a connection. In the Naza setup I cannot run the engines. No idea what I'm doing wrong
