Sir aajkal kaha ho ap

Sir there is a small mistake at 20.35 that is the minimum size of the steam pipe is 25.4mm(1inch)

How to contact with u to clearfy some doubt

What is your facebook id

Ok

Sir, how to calculate how much steam is used during soot blowing

Matarial me sab se best grade koi si hoti A,B,C me

Sir,fruitful information.thank you.but sir,voice is getting like hall background.please correct it.

Thank you sir

👍

Thanks sir 🙏, beautiful, beautifully explained sir.

Servo motor keise operate hota hai? Agar i to h mai 4 ma hai to 1.5 kg PR keise build up hota hai?

Thanks,sir

Thanks for improving our knowledge

if you use better mic, your channel will grow faster.

better mic use kar liya karo.... sound sahi se nahi ataa

Please say about seal,s there use and cause of lkg

What is the ratio of fluegas ,air

Please mention about Seal lkg reason .... Recognition.. And prevention

Brother heartily thank please send 210MW kWH turbine drawing

What is 0.9 factor please explain

What are the register to be maintain at Boiler plant.Please let me know

Respected sir... Bed coil, water wall or superheater mein kaun kaun sa heat transfer hota h.. Kis mein kaun sa heat transfer hota h? Plzz explain

Upload the video briffly Steam Control valves lift checking through servo/ pilot valves

Boiler efficiency and boiler capacit, boiler heat rate

Steam fuel ratio pr video upload kr digiye sir

boiler operation engineer ke liye ab new form kab dalega ...2024 ke liye

We are using SS316L material which is handling 310 C temp steam and we are facing caustic CSS failures frequently what is the remedy?

Sir what the difference between gague glass and hydrastep

Thanks for explaining about the IBR. Could you please let me know what is the frequency of UT & ET test of a pressure vessel?

Vortex Cylinder Material ?

Sir, May i get in touch with you for some clarification. I will not disturb you promise just for knowledge

Fecl3 coagulatnt agent hum kyun use karty Hain jab ky alum hai feso4 bhi hai

nice🙏🙏

Sir im working in hydropwerplant can uh explain the governinv mechanism in hydropowerplant how governor kept constant rpm at varying load condition?

sir height of chimney ke bare me calculation ka video bnae plz

Thank you so much sir✨

Sir, please let me know which material used in making of resins?

Experience letter kab tak valid hota hai

sir, After wet preservation of boiler. can i remove all the chemical water before start the boiler. or drain water upto 50% of steam drum then start the boiler. please confirm which on is good.

Sir WAC, SAC AND SBA, WBA, RESIN ME KYA FARAK HAI

Condenser ko full izzat

At video time 18:25 me aapne mass flow rate 1800kg/t ko 1800/3600=7kg/sec kaise aaya explain kriye jabki wo 0.5kg/sec aayega

Sir please make full details of Ro & uf plant

Please continue your classes

Thank you sir

Hi. Can anyone tell me that if GAD is approved by IBR inspector, and quantity mentioned in GAD is only one. Than can manufacturer make more than one component based on that same IBR approved GAD? Please let me know. It would be very helpful for me.

Thankusir

Many thanks for post. 🎉 in numerical-2, do we need to consider mass flow rate of Flue gas instead of coal glow rate whe calculating chimney dia. since flue gas produced per kg of coal is 14 ??

How much capacity thermic fluid is required permission for installation ?