Hi. How do you configure the settings on the hgm6120n module. I used the 0636 password which opened but couldn't set the configurations. The 0318 couldn't even open.
I have question ⁉️ cummins engine ecu data fail i have done wiring connections no cut all are good i changed ecu to new one i changed module also but same problem
thanks for the video, it describes the whole story about the emergency stop cycle... I have a strange case on my DSE 6020. It gives me the emergency stop alarm while the emergency button is not pressed !! note that my generator contains only one emergency stop button !! can you advise what needs to be done? Thank you, brother.
Emergency stop is always have a positive supply that should be use multimeter to check if there is voltage DC going back to your module if your using digital input for extra emergency stop the supply is negatively active should be
Hello. Is the speed sensor affected by heat? At uncertain times, a sensor failure alarm comes and returns to normal. Then it gives a malfunction alarm again. The sensor also gives a malfunction alarm when installed on other machines. I suspect the temperature. because when I remove the sensor and measure it after a while, I read normal ohms.
Sir.l want a data of generator. Would you give me please? Parkins generator excitor feild coil inductance value of 60.100.150.200.550kva reference by fluke digital clam
To work without sensor or with sensor if 3 pins two wire is positive and nigative last one is going to module you need to check the sensor type ither voltage type or current type sensor check the manual as will
Ok, I mean with oil sensor that have 3 pins, one is 5v the 2 others are negative and OP, where will I connect the 5 volts in module 4510 mkll. Like i connect OP to 11 pin of the dse 4510, then negative to 1 pin, where will I connect the 5 volts in the module pin? Thanks
Good job host daming mga tools spare parts iba talaga pag may alam thanks for sharing watching from Pakistan bgong kaibigan kitakitz nlang sa bhay ko slmat