13 fusion randomly dies, maybe once a week. Starts right back up and takes off no problem. No codes and driving me insane. Does this sound like the same problem you had?
do not drill grills like a butcher , those tweeters fit fine from the back , put a little bit hot glue on top, and you ll be good to go. Do not cut water shield open, it has its own purpose to protect electronics from moisture , pay attention to door clips, you actually left one or right side on the door when you pulled panel , should be transferred to its seat on panel before installation, and finally do not let wires hang out full length inside, they will vibrate and rattle there, Attention to details makes big difference .Other than that , good job
2014 ford fusion SE 1.5 1. Jerks when trying to accelerate at slow speeds 2. Has hard time going over slope super slow but engine sounds smooth Like just doesnt react 3. If driving 70mph wont accelerate have to press pedal slightly but wont detect it until ive preesed for a while so it jumps from 2nd speed to over 3rd speed and engine will sound like full action super forsed
What's up, thanks for the video. I just got my lights and was reviewing your instructions. The harness I have has a green and white wire on the DRL. The white is supposed to be a dimmer. I'm assuming the green is the L turn signal. What do I do with the white wire?
@@ljraww9064 thank you for the reply. Do you know if it is the same sensor for the 2.0l engine? Also I assume that is the low rpm sensor. What is the high rpm sensor part?
@@ljraww9064 ordered the parts. Hopefully it fixes the problem for me too. Been having the problem off and on for years and it has gotten way worse and more frequent lately. Was actually searching for something else for my car and google so happened to suggest the video for this problem. Thanks so much for this video.
My car has this problem. Stalls at low rpms. Almost getting to the point where it is dangerous ( stalling at stop signs and stop lights). Hopefully this will fix it. Thank you so much for the video. Where did you get the replacement part?
Hello Bro, I got a problem with Ford Fusion 2014 Steering system button are no working. Now it show oil change required but I change the oil. I can’t reset the massage. I like to fix that and side mirror control button. Please help me.
i also drive around a 93 accord and have been told that my car is verryyyy clean for how old it is despite haveing a few rust spots in the quarter pannels and a small dent on the hood, thats gotta be one of the cleanest accords i think ive seen in a really long time
CM5250 is the part number, also use some injector/carbon clean out stuff like seafoam. Use the map sensor hole on the intake to spray the clwaner in the the cylinders. Remove the sensor, cover the sensor hole with your thumb after inserting the straw. You have to stop the vacuum leak with your finger or it will not be happy. Replace the sensor after spraying the cleanser. Let sit for an hour then run at highway speeds to blow out the carbon. This fixed my fusion.