It’s pretty cool to see someone play this game it’s even better to know that they live half an hour from me. I’ve been grinding on this playlist for 4 days and just got to this episode!
Honestly I liked this game I had and still have an old Xbox with this game installed and I don’t have the full game and only the demo but it seemed cool and I kinda wish it got more updates and it got more love
it's kinda hard to pay attention to each step of the repair when we can't actually hear what y'all are saying as y'all are going through the process of fixing it because you chose to do a voiceover talking about random stuff part of the time.
I found you solely by chance, searching on RU-vid. I can relate to your experience. I also didn't get that kind of support or encouragement growing up, so I know it can be very impactful to hear it. You certainly deserve the praise! You're a joy to watch.
In an 8 row an S680 in 200bu corn can only go as fast as the moisture and hibred can allow. We had one field that had almost the whole plant go thru the header. No matter what speed or deck plate opening. So we had to go 4mph because of rotor loss. I would say he was doing 4.8 mph to 5.5 mph.
Doing this method would be the worst Because the hay would get in the way of the ai and other reasons, I suggest using a tractor, transport truck, or the car/truck after your done the rest of the achievements.
most flat belt machinery will run W a straight belt and other won't U have 2 put a twist in the belt 4 it 2 run the right 👉 way and most tractor company's turn engine up a bit bored cylinders out and use a bigger carb that's how they went 2 the next tractor model W out retooling or production cost alot of these that made the difference they have a high and low side or power steering all tractors didn't have this feature or flat belt pulley 😊😊 OMG 8 2O 2O23
it is a terrible thing when you have such a awesome machine well respected why you have the deck off you don't sandblast it and clean it and using a 40 lb sledgehammer a wire wheel would have been better sandblast that deck inside and out and use red primer before the moisture goes back in the metal and then take the spindles apart and check them you've got the deck off it's upside down do all the work....
Ok so I need some help please! If you take off the pad there is 1 machine screw in the center. (It's #34 in the diagram I have) it's literally the only screw with a washer when you undo the 3 screws that hold the pad/hook&loop on and remove it... there is the seal/brake(cfs disk) (#26 on diagram) the fan(#10) 2 bearing retainers(#21&22) and ball bearing (#23) THIS SCREW IS WHAT IS IN THE CENTER OF ALL OF THESE... I GOT THIS SANDER USED AND WENT TO REPLACE THE SEAL/BRAKE (CFS DISK) (#26) BECAUSE IT WAS SPEWING SAWDUST EVERYWHERE. AFTER TALKING OFF THE 3 SCREWS HOLDING THE PAD I NOTICED THAT CENTER SCREW UNDER IT (PART #98012-11 "MACHINE SCREW) IS REALLY LOOSE! IS IT MEANT TO BE LOOSE OR SHOULD IT BE TORQUED DOWN? IT JUST DOESN'T SEEM RIGHT BUT I DON'T WANT TO TIGHTEN IT IF IT'S MEANT TO BE LOOSE AND HAVE SOME PLAY. I CAN'T FIND ANY INFORMATION ONLINE ABOUT IT AT ALL! ONLY PICTURES OF THE OWNER MANUAL (COMPLETELY USELESS!) AND REPLACEMENT PARTS. CAN SOMEONE PLEASE HELP ME ASAP! I'M SITTING HERE TRYING TO DO A JOB AND THIS ISH IS HOLDING ME UP. I GUESS IF I DON'T HEAR FROM ANYONE I'LL JUST GO WITH MY GUT TIGHTEN IT AND HOPE IT DOESN'T OVERHEAT OR SOMETHING STUPID!
