Hello everyone! Welcome to my channel "General Technology Knowledge" this channel created for share knowledge to everyone related with new technology & automation system, Instruments system PLCs system, SCADA system, DCS system. Please subscribe for get more videos that I will create step by step..... Thanks you so much for like, share and subscribe my channel!
Dear sir, pray for me, i am learning from you, dhaka, Bangladesh, I every time pray for your long lives and peace be upon you & your family-your kinds-four father-mother, you my guide .
Dear sir, First install component on control panel as some feathers, Install Ms office 2010 or 2013 Install PCS7 Finally you use it. It take time around 2-3hours depend on your pc performance. Thanks!
Working with Smart V2.6 fine, but when used with v2.7 or v2.8 currently not able to communicate, kindly upload with latest version of S7-200 Smart V2.7 or V2.8.
To make I/O work for simulation or to check, you have to force it from force table. It cannot be activated/deactivated like memory bit. Thats why your overload was not working. Btw nice content. Keep it up.
Hello, I have MPI/PPI cable and I want to connect with my S7-200 SR40 Smart, when I set my PG/PC to "PC Adapter.PPI.1" and try to connect it, nothing shown in my MicroWIN Smart, just "PC/PPI Cable.PPI.1". When I'm back to PG/PC it shown "PC/PPI Cable.PPI.1" not "PC Adapter.PPI.1" that I select before. Any advice that I can try? Thanks
Hello, I have MPI/PPI cable and I want to connect with my S7-200 SR40 Smart, when I set my PG/PC to "PC Adapter.PPI.1" and try to connect it, nothing shown in my MicroWIN Smart, just "PC/PPI Cable.PPI.1". When I'm back to PG/PC it shown "PC/PPI Cable.PPI.1" not "PC Adapter.PPI.1" that I select before. Any advice that I can try? Thanks
Hello, I have MPI/PPI cable and I want to connect with my S7-200 SR40 Smart, when I set my PG/PC to "PC Adapter.PPI.1" and try to connect it, nothing shown in my MicroWIN Smart, just "PC/PPI Cable.PPI.1". When I'm back to PG/PC it shown "PC/PPI Cable.PPI.1" not "PC Adapter.PPI.1" that I select before. Any advice that I can try? Thanks
You can move exiting value to block encoder or you can set the retentive memory. Other my videos already show about how to remember value of encoder after power OFF and ON again. Thanks!
I have big problem when the signal 4ma input the output 6.3 when the current 8ma the out 17.9 when the current 12 the output out off range do you have solved to my problem
Hi friend, i am trying to access our PLC S7-200 CPU ST60 and it was found. The problem is after i press the Upload button, the microwin suddenly closed. It is not the same on your video that the blocks immediately appeared. My question is, does the program still there in the CPU and not corrupted? Thank you
Hello, I have question What if I don't click the "transfer 1 0 table and special unit setup" I forgot to click it, will project like that work correctly on brand new plc, or I should go back click it and upload project again?
