Good very helpful. What software are you using to monitor the frequency please. Blowed if I can find out watching the video several times and the pop-up box in the top left of the screen doesn't give any clues but says the USB is disconnected!! Thanks in anticipation.
I have just disassembled my QB78 due to a fault in that valve, the rubber seat has disappeared, I tried to fill the gap in the stem with silicone for engine gaskets, I will try to see if it is airtight. On the other hand, I see in its valve that the air outlet hole has been modified, what diameter drill bit should I use to enlarge the air outlet? How many shots does Co2 last for you like this? Regards
mine only produces a single pop, like every second. Changing the jumpers doesn't do anything. Ive checked ans the IC is installed the correct way, Im just not getting any sound.
Why would you need a cadence sensoe and a speed sensor? I mean if you take just the cadence sensor and input the tire's circurference you get speed, the igps is a speed sensor, but there should be a version for cadence which should work as you intended.
Hi, did the 3 magnets just stick on bythemselves? I have a cover of some sort over my magnetic flywheel so magnets will not stick to the outside. Can i use double sided tape? Also do i need the 3 magnet configuration on both sides of the flywheel or just one side? The spoke sensor- if i just stick that on somehow without drilling is that ok too? Thanks!! Your video is my only hope. There is no other information out there to help in the Zwift- elliptical compatibility dilemma!
I'm at the point that I should be using something more stable. The XR2206 in an obsolete chip, so what's out there is probably fake, and the circuits for the kits are problematic. We as builders need a new thing. Perhaps a 555 with some transistors to get a solid Triangle and Sine wave suitable for testing common emitter amp's or any other signal amp. I really tried with these cheapo's but it's frustrating. Good Video.
just used the vid to fit the new part. i needed a torch so i wouldnt cross thread, and in my torx set the T9 seemed to have a smaller end bit that fitted. T9 was the smallest in my set.
This "tab" issue I've heard others speak of, could this be the root of the problem when encountering "difficult to remove" panties that have stubbornly decided to not fall to the floor when being tugged upon.
I wonder if you were to put a small bit of JB welds on it, would that help prevent it from breaking again.. I haven't purchased this vacuum but i am highly considering it. This seems like a easy thing to prevent if the JB welds can be used. I would hate to use JB welds on a high priced vacuum but seems like a small preventative measure for a inconvenient problem down the road.
Or you can just soak the original aroma beads in essential oils of your choice??...£54...what a rip off..beware if the garage automatically change this on a service!!!! UPDATE...Yes, it works...I got some essential oils from my daughter, who does wax melts....took the aroma beads out and added 3 different oils to the 3 lots of beads...left them to soak for a few days and then put them back in the modules and refitted...boom..3 smells of your choice...
I have xbox 360 udraw tablet, Unfortunately application is unable to detect it, My xbox 360 gamepad and xbox steering wheel works perfectly fine, tablet works aswell (in games buttons work but not pen and tablet) but driver can't detect it, It works perfectly fine on my xbox 360, I tried installing application on my brothers laptop but same results. any suggestion?
Mine is a different setup and solid from 59Hz up to 1Mhz Fine takes me from 60- 3khz and the. The course will give me the upper limits past 600Khz to 1Mhz.