502 great vid very helpful

Thanks for sharing brother!

QUESTION: the fiberglass on the return duct was wet so we cut it (fiberglass around it only) opened and let it dried completely then retape it back up after it dried since we saw it was due to a clogged drain. Should we replace the entire duct or will that fix be fine? We haven't had that problem since with the fiberglass from that duct being wet.

Thank you so much!! This video helped me perfectly! Really appreciate it man!

Nice video, did you find out the specific cause?

Thanks for the video! This walked me right through it and the details were accurate!

Wat kind of screws do u use

A hero my guy!

Dude, you are my hero. Thank you.!!!!

Quick and strait to the point. Thank you.

Thank you so much!

I use a hammer everyday lol I could have hit it in swinging by junk softy’s

This is for a 1st gen GM Traverse. Has nothing to do with the newer 2nd traverse as their layout is different and less problematic.

I loved it I wish you would have shon how to clean the bladder I cleaned mine it was apart inside good job

Just did this several times and got nothing on a 2001 Silverado 😢

Dude thanks so much i was expecting to have to take the bumper off and everything this literally took me less than 5 minutes to do! Truly a time saver!

Great video, very clear.

Thx

Hello young man, You examples this step by step and I'm a woman so I can do this! Thanks so much! I don't like going to shops all day for a small job. Great job. Even touching the bulb with oily hands!

Good video. Here’s a little tip though. You don’t have to remove those plastic tabs. The soft cover thing will just fold back far enough to get those two nuts off

Thanks so much bro, thought I was throwing this one in the garbage until l stumbled up on your video and now it's good as new.

Good

Thanks brother! The Living God was here.

What if you’re an apartment building? On September 4 I started my electric bill and it’s $96 and nothing’s ever on except for a fan and a refrigerator!

Clutch video straight to the point

Bruh I wish I had found this like twenty minutes ago. I just took off the whole top cover from under the hood to get that same twenty second access you got. 😂 Thank you for sharing. I’m doing this next time. 👏🏼😂

Thank you sir! I appreciate your clear instructions, calm demeanor and time. You helped me out today. ❤

Turn off the main breaker and if the metter is still moving you have faulty wiring.

Ok but why my traction control n brake light comes on at the same time. Somebody please help me

Best and simplest break job video I've ever seen. Appreciate it man! Helped me help out my mother-in-law with her break job.

Great video. I finally hooked my phones blue tooth up to my truck, just after 9 months. I feel like it’s causing my battery to drain. I had a phone hooked up to it originally , but I got a new phone. I had a dead battery before. It’s probably not coincidence that this happened the day after I hooked my new phone up

Thank you so much. Do I need to shut off main water in basement before removing fridge waterline?

Will you need to use any sort of brake grease or lube?

Gracias. Pude montar mis luces 💪🏼

The ( usual ? ) cause is the LONG EHT fuse ( normally rated at 700 mA ) has blown .. this is almost always caused by the homeowner NOT putting ENOUGH ( food ) in the microwave cavity ( oven ! ) ... DAVE™🛑

Worse video ever..you it's too dark

Brother man, THANK YOU so so much. Needed to do this on my 2008 impala. Bless you!

Hello what is this thing called the plastic part? I had a fridge moved and the movers broke it in half. I want to replace it. Can I just buy the plastic or will the whole line need to be replaced?

Just lit and best of all ...now am one of your subsriber

Thank you so much!!! Greetings from Guatemala

6 years later, the most helpful video ive found on this, helped with our 2015!!!!

Thanks very helper taking arm oof makes its easier.

Thanks

Thanks it was driving me crazy.

Didn't know I was supposed to be wearing gloves when replacing the bulbs, to prevent risk of shortening their life. Mine have gone out 3 times so far, but- heeey wait a minute, but the guy in the video ain't wearing gloves!

Where do I get that.?wich store?

Thank you!!! Best explanation! Super easy!!

Other video I watched called for removing the entire bumper fender and head light case, I question how many times the wiper fluid filler is designed to be removed, that O ring might break eventually but I didn’t even have the trim remover tool needed to do it the other way so this vid saved me a major headache 👍

Thank you so much for sharing, it will help me save some money.

Thanks for the video man..much APPRECIATED..now I can Actually save some 💰