What axle did you use for the passenger side? I cannot find the right part for my 2013 police interceptor sedan witch a Ford Taurus and every part store O’Reillys AutoZone advanced all their websites say they have the right axle but when we take this one off and compare it to theirs them line up with the bracket that you have to unscrew the 213 mm bolts Honestly, I’m not sure what to do at this point because I can’t find the right. Axle nowhere
The same senario for one of ford taurus I've been replace, the bearing the has 3 bolt will not fit to the bracket i pull out the old bearing and put the new axle.
Yeah, I still can’t find the right one rather than using the one part store says O’Reillys for a 2013 Ford police interceptor sedan If you look up the right CV axle for that on AutoZone or O’Reillys that axle says it fits these vehicles, but it does not I had to buy the axle that doesn’t have the bracket and switch out the bracket onto the new axle that they sell for it that does work you just have to manually switch out that bracket and I didn’t know how to do that at first but now I do. . I feel like some of these interceptors are a little different than the normal Taurus even the parts store gets messed up because there is no reason they shouldn’t know what axle it is
that's a clever idea reusing the chrome bar from the car shocks, never would have thought of it. However i would have used a rear 10 stud axle from a truck for the chuck. there's a hole down the middle so that you can feed things through and the tapered bearings have low runout.
Самый тупой метод, или пример как не нужно работать. Особенно резка ручной ножовкой по всей длине заготовки, а потом сверлил как из пулемета (без масла кстати) где можно было ножовкой резать и при этом имелась болгарка! Это как закрутить лампу вместе с табуреткой.
