"Man was born to love- Though often he has sought Like Icarus, to fly too high- And far too lonely than he ought To kiss the sun of east and west And hold the world at his behest- To hold the terrible power To whom only gods are blessed- But me, I am just a man"
Introduction: Broken Gear Repair MuchadaFab C. Simple way to fix broken gear Step 1: Materials Needed to Fix Broken Gear you need a plastic steel epoxy, Popsicle stick, any mixing medium for your epoxy mixture and brush and detergent soap or dish washing liquid. Step 2: Cleaning Be sure that your gear is free from oil and dust. use dish washing or powdered soap and brush to clean the gear Step 3: Epoxy Mixture mix the two compound and apply it on the broken area. Step 4: Curing wait for an hour for the epoxy to begin hardening, since initially the epoxy is not hard enough and the epoxy is flowing slowly. You'll need to take care to monitor the flowing of the epoxy to make sure it doesn't flow over to other areas and get stuck in unwanted areas of the gear Step 5: Molding the Teeth you'll first need to put some grease or some other material on the other mating gear so that the epoxy will not stick to that other gear during this process. After an hour the resin will begin to harden to a consistency like a clay, at which time you can position the new mold gear in its gear partner, rotate slowly to adapt the teeth of the other gear. rotate it slowly till the rotation will fit fully to each gear. Step 6: Total Curing remove the gear to the gear box assembly and allow it to fully cure in a well ventilated area for a day. Step 7: Cured Epoxy Gear Install the hardened gear in the gear box, reassemble the parts.
Gusto ko po palang sabihin sa lahat na yan po ang orihinal na version ng awitin Bilog Ang Buwan ng yumao kong kaibigan na si Marcelino Sigfried Ranada, a.k.a. Ysagani Ibarra.