Im getting a p0455 and p0456. Gas cap looks new but i ordered a honda one to compare and i will return it if it doesn’t match. Were you getting those codes as well?
Funny cause wife has Honda crv 2010. Check gas cap think for a month. Replaced that. Still flashing check gas cap, and today, no gas cap message but check engine light. When the check engine solid light came on did the flashing check gas cap warning stop? Thanks, pretty sure I know the part to get!
My son just called to tell me the fuel cap light came on in his 2012 CR-V. I ordered a new cap first, but if that doesn't work, I'm totally trying this! I know it might be a little bit different in the '12, but this at least gives me an idea of what to look for. Thank you!
Thank u because I'm upset I spent 360 on replacement of my canister purge valve at a popular mechanic shop and they sold be the cheaper part, thank u for this vid because I still gotta replace it again after those mechanics. Thank u once again for this lesson vid
Bro! You are a life saver! My gas cap warning has been going on forever. Then, today (much like some of the other people that commented) my check engine light came on. Code reader said cannister system low purge flow, and system purge flow malfunction. RU-vid led me to a different video in which a tech was diagnosing the probable cause- but no explanation as to how to replace it, nor any mention of the gas cap warning. Once I saw your video and the comments, I feel certain that replacing this will kill two birds with one stone. I actually just had to remove the whole air filter box a few months ago to replace the #2 sensor on the tranny. (Throwing that up here in case any more Honda CRV owners run into that issue later!) Getting the bottom of the box off really is easy and it probably would make getting to that bottom bolt on this much easier. I confess I didn't know how to remove the bottom of the air filter box at first until I RU-vidd a similar video on a Honda Accord. It's like one bolt and then you just pull up. Mostly just slid down on the posts and held by rubber grommets. But back to your video- THANK YOU SO MUCH for putting this up here! Not all of us can afford expensive repair shops. RU-vid warriors like yourself help the rest of us folks that are trying to get by!
Got a good question I just fixed this problem today around 5:00 p.m. and drove around for about an hour and a half then drove the car around 11:00 p.m. and now the check engine light came on is there any correlation to this cuz at first for a while I was saying check the fuel cap I bought a brand new fuel cap then I bought this part that you showed how to install. But the check engine light has never come on until today so is there any correlation to the problem I fixed
Sorry to hear about the light coming on. I don’t believe there is a correlation. Have you done a OBD2 sensor scan? I wonder what the code is. Have you found out what’s causing it yet?
@@cancer652006 absolutely I have I cleared the code the code came back on it came on a few times now and like the last week that check engine light hasn't came back on so maybe the problem is totally fixed I don't know
Thank you so much!!! I have had the same problem and no one could figure it out. Autozone did their OBD checks and said that my Canister purge valve was bad... ONLY after my engine check light came on, before that it was just the gas cap warning.
Perfect execution of "Portrait of Tracy"... if only you played it with a fret less bass... Always perfect Rhonda, as always... From the 8 strings fret less bass freak from CYUL...
As the other posts, Thanks ! My warning lights were intermittent and the dealer couldn’t even pin point it. I saw your video and suggested the solenoid and that did the trick.
From my experience removing the entire airbox is the way to go to get in there for that pesky bottom bolt. The airbox is easy to remove and reassemble and gave me a lot of room to work. Don't bother trying to remove the hose in the way of the bottom bolt but use an offset box wrench since it's so narrow between the bolt and the hose and will make the replacement much easier.
