By any chance do you happen to know where the passenger seat thermal fuse is located…someone mentioned column 1, S46 location 15amp thermal fuse… the owners manual does not provide any information on power seat location for a 2014 A4 quattro
After seeing the other video and you haven't been able to find the issue....were you able to turn the motor? Be careful, I saw you remove the crank bolt on your previous vid. If you can't turn the motor I'm pretty sure it's the balance shaft(s)...usually one. This is a common issue with the motor.
engine was seized it needed a head replacement due to interference engine and bent valve… and this engine was flooded and cat blew out at time of seizure so piston on cylinder 4 was broken… i still have the car sitting hoodless and it’s looking like i’m going to buy another a4 b8.5 and swap all the parts over
yo bro my 2013 Audi 2.0t tsfi its engine blew and i wanted to engine swap it now, what are some good performance engines that can fit in the car? Thanks
Seen some LS SWAPS.. RS4 SWAP or S4 swap also possible maybe some cutting needed.. I think s4 swap is the way to go, dual pulley setup.. toss some tune you can push over 400 easy.. make sure your cooling system is fresh tho heard they give timing issues so make sure it's reliable and low mileage preferably.
I have heat, but it’s tells long for it to get hot. Feels like all vents aren’t blowing heat. Defog takes long defog windshield also. Could this be due to needing a flush?
I think all my fuses are dying. My 12V Port in the front middle console doesn't work, i have parking brake error, ABS error, ESC/ESP error... gonna fix that in the next few months
I had exactly the same problem here in Germany with my Audi A4 B8. ESC fault no motor start because of the relais. Thank you very much for your video. 🙏
Ok if you want it perfect, mine isnt either since the S8 front end swap. To get it closer, you dont actually lower the hood, but raise the core support. My S8 is at perfect gap, and my A8L is close to your gap . I couldnt be arsed to line it perfect when I did timing belt since it`s still not painted after the 2004 to 2009 S8 front end swap.
@nicholasrendon8648 yes... after aluminum water pump upgrade timing chain slipped over 160k miles on the car.. valves bent this car will be scrapped I think..
