Hi at 2:52, where you tilted up the cart, could you leave the csc50 in the cart? It’s a lot easier on my back than to have to lift it all the way to the table top. I might consider to get the cart if that is possible. Thanks.
Hello, I did try try strapping the saw into the cart and lifting with it. I was able to lift the saw with it strapped in and then lower it again back to its wheels. So it is possible. With that being said, not sure if it would put to much stress on the legs over time. Hope this helps.
Hi, thanks a lot. Great to hear it can be done. Yes, good point about stress on the joints. The unit weighs about 45 lbs. I guess if the joints are steel pins, they should be ok but risky if they are plastic. 😅