Hello, I am having a heck of a time with my understanding of the wiring to a controller for my vector. I have the sw400SSJ - there isn't a b/w wire coming out of that to connect the smart pod line. I think that I have to have the connected to light up those two smart pods. Where should that b/w connect to on the controller from the vector? Carl
Hello, I am Spanish and I have an amt 600. There is not much information here about the maintenance of this engine. Could you tell me what type of motor oil you use? and transmission? thank you
The tires on the front should be 1 inch smaller than the ones on the back. If you have 27" on the back, you should have 26" on the front. Otherwise you will screw up your front differential.
So I assume you’re from New Jersey I’m from Ohio but what places are there that fix four wheelers? And also how much was it for you? And how bad was yours? Did they buy all the new parts and then you paid them or did you buy all the new parts first and then they put it on and you paid them?
I have an AMT 600 1987 model. I can not find a wiring harness configuration. If you happen to have your seat off could you snap a quick picture and email to me. I need to see the wire configuration on the solenoid. Thanks in advance. paladin1650@gmail.com.
Yes, They Were AWESOME! The reason that John Deere stopped making the AMT: 600, 622, 626 was A: When turning on a hill they would have a greater chance of overturning. B: It was replaced with the John Deere Gator in 1992 with Models: CX, TS, TH, in 2004 John Deere Released The HPX Series of the Gator Line Up.
On your left hand side of the fourwheeler on the left brake there is a red push button you have to push that down and pull that brake to get it into reverse there is a way to override that button
It won't go into reverse because you weren't holding the reverse button and brake lever on the left. There's a little red button you push then pull the lever, THEN shift to reverse.
