Welcome to Outlaw Woodworking were we dive into woodshop related projects and review tools and learn how to do new and old projects for the first time we share our success and our failures. Subscribe and dont miss the action, we also link everything we use in the description below. Thanks for watching . Please subscribe,ring the bell and like the video.
I cant tell but I hope those are Anodeless gas risers you are using. If they are single wall Anode type will need to attach anode bags to them. Also it is good practice not to let trace wire touch polyethylene pipe because in rare cases lighting strikes to riser will conduct through trace wire melting a hole in polyethylene pipe.
Much faster to sucker nail a 2x4 to footer.....form one side of the wall and brace.......put snap ties and then form other side of wall and then sucker nail other side with a 2x4 in footer
I hope to make a piece this beautiful someday. My current shop is under the shade trees. Could you advise me on how to prevent the white part of the cedar from cracking out? I'm making cedar walking sticks and when I grind and sand, the red is fine, but when I leave some white wood it's cracks.
I find that when I’m cutting fine letters it seems to work better, I don’t always do that . Just once in a while and usually I’ll test it on some cheaper wood
I should do a updated video,been building a little house recently and using it a lot , it was square out of box , still square, at this point I think it’s been 1-1/2 years and it’s been great
@@OutlawWoodworking I would offset by 1in min, this allows you to easily sand any ghosting marks. then run a pocket tool path for the remainder. Under the modeling section you can create a vector from model.
Yah ,it was worth it for me by myself, however if you’re only going to use it on one job , probably not worth it, I’ve used it on 6 jobs so far so it’s slowly paying for itself
Cheaper to use trusses ,I was basically trying to match the garage that I already built, don’t know if there is any benefit ,I wanted the inside to be vaulted.
Enjoying the videos sir, I think I’ve commented on your posts from my Bowers Custom Woodworking account occasionally too. Just wanted you to know as one of your first subscribers that I’m quietly still watching.
That is a big help I will try that tomorrow. Unfortunately mine is leaking and I can not find a rebuild kit for it. The cost is $845..49 PN 6697935 Mine is a Bobcat E35 2015. I believe this control will fit other models I should tear into it a little bit and see if I can replace a couple of O-rings to fix the leak.
Thank you for doing this video. I just bought an e35 with lower hours and have the weird track speed issue. I asked a bobcat mechanic and he had no idea. Ill try this adjustment and see how it goes
You mentioned you have a bad back. I don't know how tall you are but do you find the table height to be adequate? I believe the 2255 is all I need but it comes standard at 28 inch deck height while you can get the 3255 at 32 inch deck height. Thanks!
Jan, if you had one full day to fish the Piedra River in late-summer (en route to somewhere else), what section would you fish? ... up in the headwaters (Williams Creek)? ... main canyon upstream from Hwy 160? ... or the Ute Reservation waters?