Please engineer, I have a nuvo oxygen generator it works for two minutes and gives a light and sound warning. The device is new. What is the problem? Thank you
Great video! Your RU-vid teardown of the Ola hub motor is commendable, I want to mention about how powerful Ola's Hub Motor is. I recently test rode the Ola S1 Air with this motor, and it was incredible, especially with the upgraded hyper mode software. The pickup and power were impressive. When I compared it to the Ola S1 Pro Gen 2, they had the same power and performance, except the S1 Air could reach a top speed of 90km/h in hyper mode. Still, the torque and power were just as good as the S1 Pro. But note, this hyper mode was activated by an Ola service engineer specifically for testing the power of the hub motor.
I agree with having a proper work area. A screwdriver, off-set fixed wrench in a word full of deep sockets and Allen wrench was it. Did he change the material or let the sun dry it out? They sell new to refill the canisters! The seal are red which tells me the an exothermic and endothermic switches back of forth between cans. Plus, I always wear sandals and no gloves. I can use duckbill pliers or "V" shaped door clip tool and spray lube works good to remove hoses, of all kinds. $10 says it beeps a problem code over 2 - 3 weeks of nightly use. If your going to change the canister materials, show us you doing this and the brand that gets replaced...if he did. I don't do this for a living but after repairing automobiles for over 40+ years, even I know better. "I have done 3 of these". Yes or no?
No sir, if the winding is burnt then it will have to be re-winded but sometimes the motor magnet also gets discharged and that too may have to be charged.
He has answered my doubt about the molecular sieve, they get wet after some time and doesn't work as efficiently sifting through oxygen, so he took them out and sun dry them, he didn't replace the expensive sieves.