Space Television specialise in the Wholesale Distribution of a wide range of products suitable for both Commercial and Retail Market segments within Southern Africa together with exports to the rest of the African Continent including the Indian Ocean Islands .
Our Commercial Product Range includes CCTV ,Security Products ,Braodband Wireless and GSM , Earth Station Antenna's, Direct to Home Satellite Dish Antenna's , Vsat Antenna Hardware ,Set-Top Boxes ,Fibre Optics ,MATV & SMATV Equipment , Coaxial Cable , Connectors ,Tools , Proffessional SAT/TV/Fibre Spectrum Analysers , IPTV Solutions ,Installation Hardware .
This is not at all how you should do it according to Corning Cablecon's own documentation: www.tme.eu/Document/149c925ca6c20b8c1c072eda638ccb7c/self-install2010.pdf * Isolation layer should not be cut off but pulled back (the braided metal) * 6.5mm of dielectric should be visible, and then again 6.5mm of copper.
Sorry but my dstv does not connect to our network bc of the connectivity thing saying its not internet connection the the wifi works well and its connected to the inverter what do i do to make the wifi connect to the dstv
Hi there I'm at the decoder setup .....it's shows 123 .....it's show no signal..... but I use my old one and there was no problem please help...decoder I have is smart one
Please i am using ws6933 satlink finder. I'm having issues with getting good signal quality. dBmv is reads -47 and jumps around like crazy. Please help me with the right settings. Thank you very much.
Question: Which way do the fiber cables connect to the switch? From the inside, out the rear to the switch? I'm having a hard time figuring out which direction goes to the switch and which side goes to the rest of the rack equipment. Thank you for any assistance.
can someone please help. cant add different satelites like vsat etc on my space ultra meter. i als have a satlink but would like to use my ultra also. cant find anything usefull on the net
Hello. My satlink ws-6933 seems not to be tracking anymore. The red signal do shows but doesn't track to show quality. Even those satellite I once used it to track, it doesn't bring quality but only the red signal bar. What can be done? Is there a way to reset it to factory reset?
Hi there, I have recently purchased a smart tv. Something strange is now happening as pictures just stop as if either the TV/decoder has gone into sleep mode and I have to switch the decoder off and then back on to get pictures again. What could be the cause of this?